Daq Configuration Tab; Daq Configuration; Real-Time Graph - BEANAIR SmartSensor BeanDevice AX-3D Quick Start Manual
Hide thumbs
Also See for SmartSensor BeanDevice AX-3D:
- Quick start manual (28 pages) ,
- Quick start manual (15 pages) ,
- Quick start manual (28 pages)
Table of Contents
Advertisement
SmartSensor
7. QUICK SETTINGS
7.1 DATA ACQUISITION CONFIGURATION
1.
Go to the configuration frame and select Data Acq. Config tab
Figure 15 :
2.
Setup your Acquisition mode
Figure 16 :
DAQ configuration tab
DAQ Configuration
3.
Click on the sensor profile to see real-time measurement graph
Find more info on the data acquisition modes available on the BeanDevice
GHZ and how to configure it on this technical note :
http://www.wireless-iot.beanair.com/files/TN-RF-008-Data-acquisition-
modes-available-on-the-BeanDevice.pdf
7.2 USING THE DATALOGGER
The BeanDevice
data points (with events dating) in the Xrange version.
You can start the datalogging from the previously demonstrated data acquisition
tab, you can select
datalogger without transmitting data to BeanScape or you can select
jointly save data on your BeanScape
the same time.
22
SmartSensor
Figure 17 :
Real-time graph
®
comes equipped with an embedded datalogger up to 8 millions
Log only
as data acquisition option for only using the embedded
®
Host computer and also in the datalogger at
2.4
®
TX & LOG
for
23
Advertisement
Table of Contents
