HI-IQ Products Q-1772-RK Assembly Instructions

Rackmount kit

Table of Contents

Download this manual

Websites: www.flatmonitors.com and www.peizen.com

Tool required:

1. No. 2 Phillips screwdriver

2. 3/8" Socket wrench

3. 3/8" Crescent wrench

4. Tie wrap tool

5. Wire cutter, angled tip is recommended

1. It is a good idea to power up and test the monitor before assembling it onto the

rackmount kit, just in case if there is any problem with it (usually very rare).

Otherwise, you may do all the work below and then have to un-do it.

2. If the monitor is working fine, then lay the foam packing material that came in

the box over a flat surface on a table or workbench. The lay the monitor facing

down over the soft foam.

3. Use a No. 2 Phillips screwdriver to remove the monitor from its stand by

removing its four metric screws and washers. Note: Please store the stand and

all the metric screws away in the box the monitor came in. In case of warranty

service, you will need to re-assemble the stand back onto the monitor.

4. Mount the U-bracket onto the monitor with four each 4 mm X 12 mm metric

screws, No. 8 lock washers, and No. 8 flat washers.

PeiZen, Inc.

1227 Flynn Road, Suite 302

Camarillo, CA 93012-6212

Phone: (805) 484-2454, FAX: (805) 383-5909

E-mail:

hlee@flatmonitors.com

Assembly Instructions

Q-1772-RK Rackmount Kit

For

of 3

Table of Contents

Do you have a question about the Q-1772-RK and is the answer not in the manual?

Page 1 Camarillo, CA 93012-6212 Phone: (805) 484-2454, FAX: (805) 383-5909 E-mail: hlee@flatmonitors.com Websites: www.flatmonitors.com and www.peizen.com Assembly Instructions Q-1772-RK Rackmount Kit Tool required: 1. No. 2 Phillips screwdriver 2. 3/8” Socket wrench 3. 3/8” Crescent wrench 4. Tie wrap tool 5. Wire cutter, angled tip is recommended Procedures: 1.
Page 2 5. Turn the monitor over facing up. 6. Assemble the L-brackets onto the U-Bracket. Adjust the L-bracket so that the monitor screen is centered with respect to the opening of front panel. Also, adjust the L-bracket so that the monitor just touches the backside of the front panel.
Page 3 crescent wrench to secure the front plate. Repeat this process with the right side. Use 5” tie wraps to secure the cables. Then trim all excess lengths of the tie wraps with a wire cutter. The monitor is now assembled. Before mounting it unto a rack, test the rackmount monitor assembly by connecting it to a computer.