Halter Technical HTMS1 Microsone-Light Manual

manual
Product Specifications
1. Product model: HTMS1 Microsone - Light
2. Bluetooth version: BT V5.0
3. Signal distance: 10m
4. Use time: 5 Hours
5. Charging time: 1 hour
6. Support mode A2DP/AAC/ADC/AG/AVRCP/GAIA/HFP/PBAP/PDL/RSSI/
SBC/SCO/SIG
Function Description
1. Power on: Take out the earphones from the charging compartment, you can connect
the Bluetooth device and use it.
2. Manual pairing is required for the first use, and automatic pairing is required for
subsequent use.
3. The two earbuds work independently.
Charging Instructions
1. Use the Type-C charging cable to charge the charging box. The power of the charging
box corresponds to the number on the display.
2. Charge the earphones: Put the earphones into the charging box, the marquee light on
the display flashes, which proves that the earphones are charging. When the marquee
stops flashing, the headset is fully charged.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation .
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This