Table of Contents
Advertisement
BatteryMINDer
®
Connect output wires from solar panel to solar controller by sliding terminal
cover on controller to expose terminals beneath. Be careful to observe
correct polarity. Do one wire at a time. Do not have solar panel exposed
to sunlight. Do not touch wires together.
Connect cord set (supplied) to battery clamps or directly to terminals
(depends on battery type) Observe polarity indications on ring end of
RED
wires:
= + (positive)
Solar Controller has three (3) separate LED status indicators: They are:
•
YELLOW
= Solar Power - Lit when sufficient sunlight is available to
charge/maintain/desulfate battery(s)
•
RED
= Polarity Reversed (Battery only) If lit RED, reverse battery
connector wires to battery.
•
GREEN
= Battery Charge If lit (solid) battery is being charged-
desulfated.
desulfated (if required).
IF NO LEDs ARE LIT, SOLAR OUTPUT IS NOT SUFFICIENT TO ALLOW
ANY FUNCTIONS TO OCCUR. YOU MUST WAIT FOR ADDITIONAL
SOLAR OUTPUT TO OCCUR, BEFORE ANY ACTION CAN TAKE
PLACE.
Note: Never try to use your SCC515 solar controller with any other
solar panels in excess of 15 watts total. Doing so will burn our your
unit and void your Warranty and 1-year Guarantee.
MOUNTING INSTRUCTIONS
Kit with Temporary and Permanent Mounting Brackets. See Figure 1.
The panel comes with two
arms for angling the panel for
a temporary installation and
four brackets for installing
the panel permanently on a
surface. The brackets and
screws are in the cut-out in the
foam underneath the panel.
Mount the panel with the black
side up and silver side down.
It must be placed in a location
where
there
sunlight.
Try to locate an area where you do not have to extend the cord. If this is
not possible, the cord may be extended by an additional 5 feet.
Rev. D-080816
BLACK/BLUE
If it blinks (flashes) battery is being maintained and
is
maximum
= - (negative).
Figure 1
Page 3
SCC515
P/N VDC SCC515-MNL
Advertisement
Table of Contents
