Dyflexis Rex-O-Matic Quick Start Guide

Information

For more information and the safety instructions, visit the Dyflexis Knowledge Base at dyflexis.com/noa or by scanning the QR code. If you need help connecting the hardware, please contact the Dyflexis helpdesk at +31 (0)880 111 567 (available during office hours) or send an email to support@dyflexis.com.

Mount the Rex-O-Matic

Place the Rex-O-Matic on a stable surface. Preferably fix the device to the wall with the supplied mounting materials.

Note: The Rex-O-Matic should not be placed in direct sunlight or in a damp environment.

Start the Rex-O-Matic

First, connect the network cable and second the power cable. Switch on the Rex-O-Matic by pressing the button under the LED strip.

The Rex-O-Matic will automatically connect to the internet within a few minutes. When the connection is successfully established, the network icon in the top left corner will light up white.

In your Dyflexis software you can check the status of your Rex-O-Matics on the settings page. The green dot indicates that the Rex-O-Matic is connected.

Register your employees

Go to the advanced settings via the menu icon at the top right, then scan the admin card to gain access.
You can now register your employees, via "employees" in the menu.

Select an employee by clicking on the name. Then select "add card" and hold the personal card in front of the card reader . When the card is registered you will hear a beep.

If you use a Rex-O-Matic with a fingerprint reader, you can perform a finger scan per employee. Select "Add finger scan" and choose which finger(s) you want to scan in the subsequent screens.

If you add both a card and a fingerprint, the employee can use both options to clock in and out. Once you have registered all employees, the Rex-O-Matic will be fully operational. Your employees can now clock in and out.

Box content