Elcoma Life LL-TK Series Installation Manuallines

Included Materials

Č One (1) seat assembly with attached wall brackets
Č
Č One (1) middle support "slide" bracket (NOT on seats with legs)
Č
Č Six (6) to Eight (8) 1/4" X 2 1/2" stainless steel screws (qty. depends on config.)
Č

Tools and Materials (not included)

Č Drill - electric or manual
Č
Č 3/16" drill bit
Č
Č 1/4" drill bit
Č
Č 24" level
Č
Č Silicone caulk
Č
 Safety Cautions
Č Due to variance in local building codes and requirements, the guidelines laid out here are
Č
suggestions ONLY. It is STRONGLY ADVISED to ONLY contact a qualified contractor for application
specific advice.
Č Folding Shower Seats are ONLY as strong as the material(s) to which they are mounted.
Č
Č This seat is intended for seating one person at a time. DO NOT attempt to stand, kneel, or use the
Č
seat for any other purpose than for sitting.
Č The folding seat is designed to support up to 400lbs with wall brace and up to 600lbs with legs
Č
when properly installed to a strong surface. Improper installation may lead to bodily harm.
Č IMMEDIATELY discontinue use of the seat if visual signs of fatigue or wear become evident. Regular
Č
inspections should be made to confirm that the seat is NOT pulling away from the wall. If the wall
brackets start to pull away, stop and contact a qualified contractor for repairs.
Page 1
FOLDING SHOWER SEATS
Installation Guidelines
Elcoma Metal Folding Shower Seats