Quoizel QF5118C Installation Manual

Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Light Source: (1) A19 Medium Base 100W bulb Maximum, bulb not included.
Estimated Assembly Time:
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Missing Parts? Contact your original place of
purchase.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
Crossbar
A Assembly
x 1
STEP 1 - Installing the Crossbar Assembly
A. Pass the supply wires from outlet box through the Crossbar
Assembly (A). Attach the Crossbar Assembly (A) to the Outlet Box
with the head of the Green Ground Screw facing you. Secure the
Crossbar Assembly (A) with Outlet Box Screws (not included).
Tighten until snug.
Outlet Box
Supply Wires with
Ground Wire
-
STEP 2 Test Fitting Ceiling Canopy to
Crossbar Assembly
A. Remove mounting balls from the Crossbar
Assembly (A). Fit the Ceiling Canopy
the Crossbar Assembly (A) and secure with
mounting balls. Note: The
(D) should be snug against the
the mounting balls. If not, adjust the length
of the nipple on the Crossbar Assembly (A)
by unscrewing the preassembled hex nut
and lock washer and then screwing the
mounting screws in or out of the crossbar
until the correct length is achieved. Once the
Ceiling Canopy (D) is secure, remove the
mounting ball and Ceiling Canopy (D) and
proceed to Step 3.
2018 QuoizelInc.
for product cleaning tips. Go to the
20-30 minutes
Fixture
B Body
x 1
Figure 1
A
Outlet Box Screws
(not included)
(D) to
Ceiling Canopy
ceiling and
Figure 2
visit us on-line at www.quoizel.com
Installation Guide #IS-QF5118C
For Style QF5118C
Care + Maintenance selection.
STEP 3 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
White wire
from outlet box
Black wire from
outlet box (or Red)
Bare, or Green
Ground wire
from outlet box
-
STEP 4 Install the Fixture
A. Carefully tuck all wires into the outlet box and position the Ceiling
Canopy (D) over the outlet box. Align the holes in the Ceiling Canopy
(D) with the mounting screws, then attach the Ceiling Canopy (D)
using the previously removed mounting balls. Hand tighten until
snug.
A
D
1of2
White wire
from fixture
Black wire
from fixture
Ground wire
from Fixture
Green Ground Screw
Figure 3
on the Crossbar
A
Mounting Screw
Mounting Ball
Figure 4
D
ReleasedDate:2018-12-27