Home Accents Motorcycle Riding Reaper Easy Assembly And Operation Instructions

EASY ASSEMBLY AND OPERATION INSTRUCTIONS
Motorcycle Riding Reaper
This item, when assembled by the following instructions, should take 15 minutes to assemble.
Please follow the step by step guide and enjoy your Motorcycle Riding Reaper!
CARE AND STORAGE INSTRUCTIONS
For best performance operate your item indoors. When not in use, store this
product in it's original packing. Keep away from heat and moisture.
PARTS LIST
A. Base
B. Gas Tank/Motor
C. Back Wheel
D. Left Exhaust Pipe
E. Right Exhaust Pipe
F. Front Wheel
G. Handle Bars
H. Headlight
I. Function Control Box
J. Shoulder Ring
K. Head
L. Legs
M. Shirt
N. Coat
O. Right Arm
P. Right Hand
Q. Left Arm
R. Left Hand
S. Bandana
T. Fog Machine Adapter
U. Fog Hose
V. Polybag with Small Parts
(Attached to the B. Gas Tank/Motor)
* Adapter
BEFORE ASSEMBLING, REMOVE ALL THE ABOVE PARTS FROM BOX. IF ANY PART IS MISSING, DO NOT ATTEMPT TO ASSEMBLE THE PRODUCT AND CONTACT CUSTOMER
SERVICE FROM 8:30AM TO 5:30PM PST AT 1-855-428-3921.
B
B
A
STEP 1
NOTE: The longer end of the (A) Base goes towards the back of the cycle. Attach the ends of the
support poles at the bottom of the (B) Gas Tank/Motor to the (A) Base and secure by aligning the
quick-connect push buttons into the pre-drilled holes as shown in Figure 1.
NOTE: Remove the (V) Polybag with Small Parts from the (B) Gas Tank/Motor. Next, attach the loose
end of the support arm connected to the box on the (A) Base to the back support of the (B) Gas
Tank/Motor and secure using a cotter pin from the (V) Polybag with Small Parts as shown in Figures
2. & 3.
WARNING
This item is not a toy and should be used for decoration only. This item contains small parts that can be a choking hazard.
Keep all plastic and wire parts away from children.
1. Please use the transformer supplied by manufacturer.
2. Please assemble item according to instructions. Connect all wires according to matching color.
3. Children should be supervised by adults. Item should not be grabbed, as it becomes a tipping hazard.
Keep all away from the transformer, as it heats up during operation.
Please read all instructions carefully before assembling. Save this instruction sheet for future reference.
A B
I J K
1
2
3
A
cotter pin
B
A
2
C D E
L M
N
1
C
3
STEP 2
Assemble the (C) Back Wheel to the (A) Base by aligning the hole located at the bottom of the (C)
Back Wheel and sliding it down onto the small pole located at the back of the (A) Base as shown in
Figure 1. Next, attach the loose ends of the support arms connected to the back of the (A) Base
around the exposed screws located on both sides of the (C) Back Wheel and secure with wing nuts
from the (V) Polybag with Small Parts as shown in Figures 2. & 3. DO NOT overtighten the wing nuts
to the exposed screws.
Model#5124415
F G
O S
P
Q
U
R
C
A
C
A
2
H
T
V
Wing nuts x 4
Cotter pins x 2
1
3
1/5