Linksys EG1032 Quick Installation

®
A Division of Cisco Systems, Inc.
Package Contents
• 10/100/1000 Gigabit Network
Adapter
• User Guide CD-ROM
• Quick Installation
• Registration Card
10/100/1000 Gigabit

Network Adapter

Quick Installation
WIRED
Model No. EG1032
Model No.
1

Installing the Adapter

Before installing the Adapter's Driv-
ers, you must physically install the
Adapter.
A
Power off your PC and any
peripheral equipment
attached to it. Unplug your
PC's power co
rd.
B
Open your PC's case, and
locate an available PCI slot on
the motherboard. Check with
your computer manufacturer if
you need instructions.
C
Remove the metal PCI slot
cover on the back of the PC.
D
Insert the Adapter into the PCI
slot. Make sure that all the pins
are touching the slot's con-
tacts. You may have to apply a
bit of pressure to slide the
Adapter all the way in.
E
After the Adapter is set firmly in
place, secure its fastening tab
to your PC's chassis with a
mounting screw. Then, close
your PC's case.
F
Connect one end of the Ether-
Quick Installation net network cable to the RJ-45
port of the Adapter. (Category
5e or better Ethernet network
cabling is required for Gigabit
transmission speeds.)
G
Connect the other end of the
Ethernet network cable to your
network's Gigabit switch port.
Reconnect your PC's power cord,
and then power on your computer.
D
E
F