Installing The Handle; Reversing The Door Of Your Wine Cooler - Wren Kitchens WRWC30BKED User Instruction Manual

IMPORTANT: Do not move the appliance when the feet are adjusted high.

Installing the handle

o Remove the door gasket on the side you wish to install the handle. You can see two designated holes for
handle installation.
o Install the handle tightly as shown in the diagram above with the two screws, lock washers and flat
washers provided.
o Replace the door gasket.

Reversing the door of your wine cooler

This appliance has the capability of the door opening from either the
left or right hand side.
If the installation site requires. Tools you will need:
1. Cross-shaped screwdriver
2. Putty knife or thin-blade screw driver
Before you start lay the wine cooler on its back in order to gain access to the base, you should rest it on soft foam
packaging or similar material to avoid damaging the cooling pipes at the rear of the wine cooler.
3. Stand the wine cooler, open the door and remove the shelves and close it (preventing the shelves damaged).
4. Remove the bottom hinge by unscrewing the four lock screws. Be careful to hold the glass door firmly after
removing the screws.
13