Seiko SSQV038 Manual page 18

Table of Contents

Advertisement

At trouble
At trouble
When  the  watch  is 
When  the  watch  is 
unable  to  receive  a 
unable  to  receive  a 
radio signal
radio signal
Reception 
Reception 
The  reception  results 
The  reception  results 
of a radio 
of a radio 
have  failed  and  the 
have  failed  and  the 
signal 
signal 
second  hand  points 
second  hand  points 
to  N  (the  watch  does 
to  N  (the  watch  does 
not  receive  a  radio 
not  receive  a  radio 
signal).
signal).
The  stopped  watch  was 
The  stopped  watch  was 
exposed  to  an  adequate 
exposed  to  an  adequate 
Charging 
Charging 
light  for  longer  than  the 
light  for  longer  than  the 
7
the solar 
the solar 
time required to fully charge 
time required to fully charge 
the watch,  however, it does 
the watch,  however, it does 
battery
battery
not resume its normal one-
not resume its normal one-
second interval movements.
second interval movements.
148
At Trouble
At Trouble
The watch temporarily 
The watch temporarily 
gains or loses time.
gains or loses time.
The  reception  results 
The  reception  results 
are  successful,  but 
are  successful,  but 
Misalignment 
Misalignment 
the  precise  time  is 
the  precise  time  is 
not displayed.
not displayed.
of the time and 
of the time and 
hand positions
hand positions
T h e   s e c o n d   h a n d 
T h e   s e c o n d   h a n d 
position  is  not  correctly 
position  is  not  correctly 
aligned in  the reception 
aligned in  the reception 
results  display   or  the 
results  display   or  the 
reception level display.
reception level display.
7
The watch displays an incorrect time 
The watch displays an incorrect time 
hour unit, even though it displays the 
hour unit, even though it displays the 
precise time of minutes and seconds
precise time of minutes and seconds
150
Possible causes
Possible causes
The watch was moved while it was receiving a radio signal. 
The watch was moved while it was receiving a radio signal. 
(It takes 12 minutes at the longest to receive a radio signal successfully.)
(It takes 12 minutes at the longest to receive a radio signal successfully.)
The  watch  was  left  where  the  radio  signal  was  weak  or 
The  watch  was  left  where  the  radio  signal  was  weak  or 
where it was unable to receive a radio signal (P.106).
where it was unable to receive a radio signal (P.106).
  T ransmitting stations may have stopped transmitting 
  T ransmitting stations may have stopped transmitting 
radio signals for some reason (Transmission stop).
radio signals for some reason (Transmission stop).
The  watch  is  set  to  a  time  defference  for  the 
The  watch  is  set  to  a  time  defference  for  the 
regions out of the radio signal reception range.
regions out of the radio signal reception range.
The amount of exposed light is too weak.
The amount of exposed light is too weak.
The time for charging the watch is not sufficient.
The time for charging the watch is not sufficient.
The  built-in  IC  of  the  watch  has  fallen  into  an 
The  built-in  IC  of  the  watch  has  fallen  into  an 
unstable condition.
unstable condition.
Possible causes
Possible causes
The watch has been left in an extremely high or 
The watch has been left in an extremely high or 
low temperature place for a long time.
low temperature place for a long time.
The watch fails to receive a radio signal correctly as 
The watch fails to receive a radio signal correctly as 
a result of external influence (incorrect reception).
a result of external influence (incorrect reception).
The hand positions were misaligned as a result of external influence.
The hand positions were misaligned as a result of external influence.
The hands are out of the preliminary position as a result of external influence. 
The hands are out of the preliminary position as a result of external influence. 
→ Preliminary Position P.144
→ Preliminary Position P.144
The  second  hand  is  out  of  the  preliminary 
The  second  hand  is  out  of  the  preliminary 
position as a result of external influence. 
position as a result of external influence. 
→ Preliminary Position P.144
→ Preliminary Position P.144
T h e   w a t c h   m a y   b e   s e t   t o   a   w r o n g   t i m e 
T h e   w a t c h   m a y   b e   s e t   t o   a   w r o n g   t i m e 
difference  from  the  region  where  the  watch  is 
difference  from  the  region  where  the  watch  is 
currently used.
currently used.
Solutions
Solutions
Do not move the watch while it is receiving a radio signal.
Do not move the watch while it is receiving a radio signal.
Because it takes time to receive a radio signal successfully, leave the watch untouched for 12 minutes at the longest.
Because it takes time to receive a radio signal successfully, leave the watch untouched for 12 minutes at the longest.
Place the watch where it is able to easily receive a radio signal.
Place the watch where it is able to easily receive a radio signal.
Check the website of each transmitting station for further information concerning 
Check the website of each transmitting station for further information concerning 
a transmission stop.  Attempt to receive a radio signal again after a while.
a transmission stop.  Attempt to receive a radio signal again after a while.
1.   C heck the time difference that the watch is currently set for, and select the time difference 
1.   C heck the time difference that the watch is currently set for, and select the time difference 
to the radio signal reception range.
to the radio signal reception range.
2. When the watch is not displaying the precise time, receive a radio signal again if necessary.
2. When the watch is not displaying the precise time, receive a radio signal again if necessary.
The  time  required  for  charging  the  watch  depends  entirely  on  the 
The  time  required  for  charging  the  watch  depends  entirely  on  the 
amount of exposed light the watch receives.
amount of exposed light the watch receives.
Refer to  Standard Charging Time  to charge the watch.
Refer to  Standard Charging Time  to charge the watch.
Refer to  In Case of an Abnormal Movement  to reset the system.
Refer to  In Case of an Abnormal Movement  to reset the system.
Solutions
Solutions
1. When the watch returns to a normal temperature, it will display the precise time as before.
1. When the watch returns to a normal temperature, it will display the precise time as before.
2. If the watch still gains or loses the time, conduct manual reception if necessary.
2. If the watch still gains or loses the time, conduct manual reception if necessary.
3.   I f the watch cannot resume normal movement even after conducting the above mentioned 
3.   I f the watch cannot resume normal movement even after conducting the above mentioned 
procedures, consult the retailer from whom the watch was purchased.
procedures, consult the retailer from whom the watch was purchased.
1. Place the watch where it is able to receive a radio signal more easily. 
1. Place the watch where it is able to receive a radio signal more easily. 
2. Conduct manual reception if necessary.
2. Conduct manual reception if necessary.
1.   N o  crown  or  button  operation  is  needed,  since  the  automatic  hand  position 
1.   N o  crown  or  button  operation  is  needed,  since  the  automatic  hand  position 
adjustment  function  will  be  activated  to  align  the  hand  positions.  Automatic 
adjustment  function  will  be  activated  to  align  the  hand  positions.  Automatic 
Hand  Position  Alignment  Function  activates  once  an  hour  for  the  minute  and 
Hand  Position  Alignment  Function  activates  once  an  hour  for  the  minute  and 
second hands and at 12:00 both for the AM and PM for the hour hand.
second hands and at 12:00 both for the AM and PM for the hour hand.
2.   I f the watch still gains or loses time, refer to  In Case of an Abnormal Movement  
2.   I f the watch still gains or loses time, refer to  In Case of an Abnormal Movement  
to perform procedures.
to perform procedures.
3.   I f the watch cannot resume normal movement even after conducting the above 
3.   I f the watch cannot resume normal movement even after conducting the above 
mentioned procedures, consult the retailer from whom the watch was purchased.
mentioned procedures, consult the retailer from whom the watch was purchased.
Check  the  time  difference  that  the  watch  is  currently  set  for,  and 
Check  the  time  difference  that  the  watch  is  currently  set  for,  and 
select the time difference to where the watch is used.
select the time difference to where the watch is used.
Reference pages
Reference pages
P.105
P.105
P.139
P.139
P.105
P.105
P.107
P.107
P.116
P.116
P.99
P.99
P.111
P.111
7
P.154
P.154
149
Reference pages
Reference pages
P.138
P.138
P.105
P.105
P.138
P.138
P.144
P.144
P.141
P.141
P.154
P.154
7
P.116
P.116
151

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ssqv064Ssqv046Ssqv072Ssqv040Ssqv062Ssqv056

Table of Contents