Linksys NSS4000 Technical Bulletin page 9

Note to Customers Using the NAS with a Linksys One Services Router
After the firmware upgrades and the system reboots, Linksys recommends that you perform the NAS firmware upgrade procedure
a second time by repeating Step 1 through Step 5 in the "Upgrading the NAS Firmware" section.
The services router (SVR) requires that the NAS use the latest firmware that is compatible with the SVR system firmware. If you are
running an older release of the SVR system firmware, you may see the GUI from the NAS maintenance window display inactive or
grayed-out buttons. These buttons will become active as the SVR and NAS complete the upgrade process to compatible firmware. If
you have difficulty during the recovery process with the SVR or have other questions, contact Linksys Customer Support.
Backing up the NAS Configuration
You must back up the current configuration on the NAS so that you can restore it in the future.
NOTE:
The configuration data can be saved on the recovery USB flash drive; however, we recommend that you use a different USB
flash drive and store it in a safe place.
Perform the following steps to back up the NAS configuration:
1. Using a web browser, access the system's administrative graphical user interface (GUI) by entering the IP address of the NAS in
the browser's address field.
2. Click Admin > Configuration.
3. In the Stored Configuration Location field, click the down arrow and choose the USB drive as the new location. (See note above
regarding using the recovery USB flash drive.)
Update.
4. Click
Page 9