Advertisement
Quick Links
Advertisement
Summary of Contents for Saris 28879
- Page 1 Customer Service 800.783.7257 OUTDOOR PARKING SYSTEM sarisinfrastructure.com INSTALLATION...
-
Page 2: Tell Us What You Think
Please read and understand the following instructions before beginning your installation. Everyone here at Saris wants you to be happy with this product. Please contact us (sales@sarisinfrastructure.com, 800-783-7257) should you need anything. -
Page 3: Flange Mount
Level A. Temporary Mount (P/N 28879) & Temporary Secure A. Temporary Mount (P/N 28879) & Temporary Secure Mount (P/N 26270)-Sold Separately *DO NOT THROW AWAY THE PENTA SOCKET AFTER COMPLETING THE INSTALLATION. YOU WILL NEED IT TO REMOVE THE Mount (P/N 26270)-Sold Separately A. - Page 4 6. Next, insert the drop in anchor with the open side up. Tap lightly to get the anchor flush with the base material. 6. Next, insert the drop in anchor with the open side up. Tap lightly to get the anchor flush with the base material. 7.
- Page 5 III. Corral Mount 9. Before tightening everything down, make sure the Corral Assembly rack is level and adjust accordingly with washers III. Corral Mount underneath the flanges 1. Level Prop rails up on blocks of wood to provide ample clearance for a socket wrench underneath. 2.
- Page 6 Blow the hole clean of dust and other material. 1. Determine desired location of unit. A. Temporary Mount (P/N 28879) & Temporary Secure Mount (P/N 26270)-Sold Separately 4. If you are assembling an 8, 10 or 12-bike corral, you will Drive spike through the rail and into hole, until head of spike is seated on the flange mount.
- Page 7 • 3/8” drive ratchet • Marker or Pencil • 7/32” hex key • Level *DO NOT THROW AWAY THE PENTA SOCKET AFTER COMPLETING THE INSTALLATION. YOU WILL NEED IT TO REMOVE THE 4. Before starting to drill the hole, it is important that eye EQUIPMENT IF THAT IS NECESSARY.
- Page 8 with the open side up. Tap lightly to get the anchor flush with the base material. insert it into the anchor. Strike the setting tool with the hammer several times until the set tool h the open side up. Tap lightly to get the anchor flush with the base material. ill ensure the anchor is properly set.
- Page 9 (3) its failure resulted from a defect in material or workmanship and not from normal wear expected in the use of the product; (4) the product or part is delivered, freight prepaid, to Saris Products.
Need help?
Do you have a question about the 28879 and is the answer not in the manual?
Questions and answers