Current Evolve Petro ECLP Series Installation Manual page 2

Evolve Petro Canopy Light (ECLP)
®
1 Unpacking/Handling
•
during transit.
• To avoid damage, do not impact or stack luminaire
after removal from packaging.
2 Mounting
WARNING
RISK OF INJURY OR DAMAGE. Unit will fall if not installed
properly. Follow installation instructions.
2a. Preparing Canopy for Mounting
1. Drill a 4" open hole in the canopy. If an existing hole is
less than 4", enlarge the hole to 4". (See Fig. 1)
2. Clean all areas that will be sealed.
Figure 1
2b. Install the Backplate to the Deck
1. Using the supplied deck screws, attach the backplate
to the canopy, as in Fig.2.
2. The boss and hub should go through the center of the
hole in Fig.1, such that the central gasket is positioned
as shown In Fig.3.
3. Use 30in-lbs of torque for the mounting screws
(do not over tighten or strip screws). Do not mount
to ceiling material 22ga or lighter.
Figure 2
2
Figure 3
2c. 90° Degree Elbow Installation
• Obtain a UL-listed 3/4" NPT 90° degree liquid tight
conduit elbow (not provided) suitable for the type of
conduit used in your installation.
— Recommended elbow conduit is Raco 3423
• Remove and discard sealing ring and locknut from
conduit elbow if present.
• Wrap 2 layers of PTFE pipe tape on the male thread, in
the direction of the thread spiral
• Tighten fitting into the hub, finger-tight
• With wrench, tighten fitting an additional 2-3 turns,
ending with the elbow pointing in the desired direction.
Figure 4
Figure 5
Installation Guide