Spraying Systems Co TeeJet 801 Series Specification And Installation Instructions

I N S TALL ATI ON
8 0 1 / 8 0 2 F L O W M E T E R S
INSTALLATION, SPECIFICATION, AND WARRANTY INFORMATION
Please read before installing this equipment. Failure to do so may void your
warranty.
Installation
The 801 and 802 flow meters give the best accuracy when there is a smooth,
unobstructed flow through it. To minimize turbulence, there should be at least
12"/30cm of straight plumbing upstream from the flow meter and at least
6"/15cm of straight plumbing downstream from the flow meter. Mount the flow
meter in a location that physically protects it from damage and allows liquid to
drain away after the sprayer is flushed and secured at the end of the operating
day. A straight, vertical section of the main boom supply line is the ideal location
for the flow meter.
Keep the flow meter from lying in a low section of the sprayer plumbing.
This is particularly important in cold weather when water might freeze in the
flow meter and cause damage to the unit. It is also important when applying
chemical suspensions which may settle out and stall the flow meter turbine if
they cannot drain away.
Before installing the flow meter insert, make sure there are no obstructions in
the insert cavity. Clearance at the bottom of the cavity is very close and over
compressing of foreign material in the cavity can cause damage to the flow
meter body. For 801, turn the insert locking collar until it is hand tight. For 802
install the flow meter insert until the pin openings are aligned.
Prior to each day's spraying, the flow meter should be inspected to ensure there
are no leaks around the attachment fittings. At the end of the day, care should
be taken to thoroughly flush the flow meter with clean water.
Make sure no water or sediment is trapped in the flow meter
The impeller type flow meters supplied by TeeJet Technologies are inherently
rugged. However, continued use over time will eventually wear the internal
bearings and shafts until the meter becomes inaccurate. Replacement kits are
available to repair the flow meters. Contact your TeeJet Technologies dealer for
these parts.
Flow Meter Sensor
Main Flow Meter Body
Sensor
Bolt
O-Ring
Hose Barb
Flanged
Clamp
8 0 1 & 8 0 2 F L O W M E T E R S
Connector, Deutsch 3 Pos/Skts
Pin Out Color Function
A Red +4.5V to 16V
B White Signal
C Black Ground
To Booms
> 6"/15cm
>12"/30cm
Auto Range®
Valve
Connector, Conxall 3 Pos/Pins
Pin Out Color Function
1 Black Ground
2 White Signal
3 Red +5V
NOTE: The Flow Meter
must be mounted so that
it will drain completely
when the sprayer is not
operating
Flow Meter
Pump Discharge
Main Product
Pump
Bypass Line
www.teejet.com