Nabco 15-14822 Instructions

1 The 3-Point Lock
The Hurricane Door Slide door is installed with a 3-Point Lock that operates with a Thumb Turn, or Lever Turn. The 3-Point Lock is
used to simultaneously lock the Slide door with (1) Hook Bolt and (2) Lock Rods. Please see Figure 1.
Lock Rod
Hook Bolt
Unlocked Posi on
Lock Rod
THUMB TURN
3 POINT LOCK
When the 3-Point Lock is turned to lock the Slide door; the Hook Bolt simultaneously inserts into the Strike Stile while the Upper Lock
Rod inserts into the Header and the Lower Lock Rod inserts into the Track/Floor. Please see Figure 2.
2 Troubleshoot the 3-Point Lock
2.1 The Lower Lock Rod can not be inserted into the Drilled Hole
1. Open the Slide door to inspect the Drilled hole. Please see Figure 2.
2. Remove any dirt or debris that is lodged inside the hole.
a. It is important to keep the Drilled Hole free from dirt and/or debris at all times.
b. It may be necessary to redrill the hole if dirt or debris becomes too tightly packed and cannot be removed otherwise.
2.2 The Lower Lock Rod hits the Track/Floor
1. Jiggle the Slide door to carefully center the Lower Lock Rod to the Drilled Hole.
a. Please call your Corporate Headquarters according to procedure, to start a Service Work Order if the Lower Lock Rod still
can not be inserted into the Drilled Hole.
DN 1125
Nabco Entrances Inc. S82 W18717 Gemini DriveMuskego, Wisconsin 53150
Phone: (877) 622-2694 Fax: (888) 679-3319 www.nabcoentrances.com
Locked Posi on
Slide Door
Drilled Hole that is
packed with Dirt or Debris
Hurricane Slide Door Lock Instructions
P/N 15-14822 Rev 8-21-14
Hook Bolt
Unlocked Posi on
LEVER TURN
3 POINT LOCK
Lock Rod
Figure 2 Troubleshooting the Lower Lock Rod
Lock Rod
Locked Posi on
Lock Rod
Figure 1 3-Point Lock
Lock Rod not centered
to the Drilled Hole
DN 1124
1 of 2