Advertisement
Product assembly
Step 1
Unpack the product (A) and remove all packaging.
Be careful not to scratch the surface of the product whilst removing the
wrapping.
Step 2
Fit the shade glass (B) by first loosening the three thumbscrews attached
to the lamp holder section but do not remove screws fully. Place the
shade glass over the lamp holder until the fluted end of the shade in
contact with the lamp holder. Holding the shade in place, tighten the
screws a little at a time so they secure the glass evenly on all sides.
Take care not to overtighten as this may cause damage to the fitting.
Ensure glass is fully secured before leaving unattended.
Step 3
Fit the bulb: type and wattage as indicated on the fitting.
The wattage indicated must not be exceeded.
Your table lamp is now ready to be plugged into the wall socket and is
ready to use.
1
3
4
B
A
Advertisement
