How To Use - Xiaomi Smart Tower Heater Lite User Manual

How to Use

Before Use
• Check if the heater is in good condition, and make
sure the power cord is not damaged or broken.
• Use a 220–240 V AC electrical outlet with a rated
current of at least 10 A. It is recommended to plug
the power cord into a wall socket, and do not share
the same power strip with other appliances.
• Press the power button on the back of the heater
before use. When the heater makes a notification
sound, it is connected to power.
• This heater is an electric appliance for close use.
When using the heater to blow air directly, it is
recommended to place it one to two meters away
from you for optimal heating performance.
On/Standby
• Press the on/standby button to turn on the heater.
• Press the on/standby button when the heater is
on, the heater will dissipate heat for 30 seconds,
then enter standby mode.
Note: After the heater has been running in the
natural mode for 30 seconds, pressing the on/
standby button can make the heater directly enter
standby mode.
• Press the on/standby button when the heater
is dissipating heat, the heater will return to the
previously used settings.
Note: When planning not to use the heater for a long
time, make sure the heater is in standby mode and
then turn off the heater and unplug the power cord.
Switching the Mode
• Press the mode button to cycle through the modes
of constant temperature, hot, warm, and natural.
Adjusting the Expected Temperature
• Press the temperature button to cycle through the
expected temperatures of 22°C, 24°C, 26°C, and
28°C.
• After the expected temperature is set, the heater
will automatically enter the constant temperature
mode. Other modes do not support the settings of
the expected temperature.
Note: If the room temperature is higher than
the expected temperature in the constant
temperature mode, the heater may switch to the
natural mode.
Scheduled Standby
• Press the scheduled on/off button to cycle
through the scheduled standby times: one hour,
two hours, four hours, eight hours, and off.
• If no operation is performed within three seconds
after the scheduled standby time is selected, the
indicator will display the expected temperature. If
no expected temperature is set, the indicator will
go out.
• After the scheduled standby time is selected, the
indicator will show the remaining time once you
press the scheduled on/off button. You can press
the button again within three seconds to cycle
through the scheduled standby times.
Enabling/Disabling Oscillation
• Press the oscillation button to enable or disable
the oscillation mode.
Enabling/Disabling the Child Lock
• To enable or disable the child lock function, press
and hold the oscillation button and the mode
button simultaneously for seven seconds.
• The child lock function can also be disabled by
turning on the heater again after disconnecting it
from power or unplugging the power cord.
Enabling/Disabling the Wi-Fi
• To enable or disable Wi-Fi, press and hold the
scheduled on/off button and the oscillation
button simultaneously for seven seconds.
Resetting the Wi-Fi
• Press and hold the scheduled on/off button
and the temperature button simultaneously
for seven seconds. When the heater enters the
network configuration mode, the Wi-Fi is reset
successfully.
5