TnB SHINE - Bluetooth Headphones Manual

PAIRING THE HEADSETT

1. Please make sure the headphone is off before pair.
2. Press button until the indicator light starts flashing red and blue alternately.
3. Turn on the bluetooth function of your phone or another Bluetooth device.
4. Search for the bluetooth devices named « TNB SHINE ».

If pairing is successful, the blue light indicator starts flashing
It will connect to the pre-set phone automatically when turns on.
If the pairing in not successful, please switch off headset firstly and then try again full pairing process.

SWITCH ON/OFF

• Power on: Press button for 3 seconds until the blue indicator light flash.
• Power off: Press button for 3 seconds until the red indicator light flash 2 seconds then goes off.

ANSWER PHONE CALLS

• To answer a call, press the button.
• Reject call: press long button about 2-3 seconds.
• To hang up, press the button. The music will resume automatically.

LISTEN TO MUSIC

BLUETOOTH MODE

To listen to music with your wireless headset, make sure they are paired with a Bluetooth device. If you are using your headset for the first time, please go to the «Pairing the headset» section of this manual.

WIRED MODE

In any mode, plug your device to your headset with 3,5mm jack cable and play your music. The headset will automatically switch to Wired mode.

MICRO SD/TF MEMORY CARD MODE

In power-on mode, insert TF/micro SD card (min 16 Go, max 32 Go) inside memory card slot and short press M button to switch to TF card playback mode.

FM MODE

In power-on mode, short press button 2 times to radio mode.
Under radio mode, click M button, radio automatically scans all FM frequencies and keep in memory all available channels.

PLAY / PAUSE

• Press the M button once to pause
• Press the M button once to play again

TRACK MANAGEMENT

• Long press the - button to return to the previous track
• Long press the + button to go to the next track

VOLUME MANAGEMENT

• Press the - button once to decrease the volume
• Press the + button once to increase the volume

CHARGING THE HEADSET

Insert USB cable into USB port which have support 5V voltage. Connect charging cable to the charging port of headset.

When the red light is on, the headset is in charging. When the red light will be off, the headset is fully charged, it takes about 2 hours to charge the headset fully. The battery is rechargeable.

When the battery is low, you will hear the alert tone «power off» and the indicator turns into red that indicate that the battery has run out, it needs to charge as soon as possible. You must fully charge the battery when using it for the first time. Full charge takes about 2-3 hours.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download TnB SHINE - Bluetooth Headphones Manual