Zap N Trap 605BZ150WOUT Instructions

Outdoor Insect
Trap/Zapper
Item No: 605BZ150WOUT
150W
Input: 120V
Dimensions: 12¼" D x 28¼" H
Usage: Indoor/Outdoor
Replacement Bulbs: #60550WATTOUT
BEFORE OPERATING ANY EQUIPMENT, READ & FAMILIARIZE YOURSELF WITH THE USE & SAFETY INSTRUCTIONS

SAFETY PRECAUTIONS

CAUTION: This equipment gets HOT. Make sure
from this equipment.
• Do not operate any appliance with a damaged cord or plug,
any manner.
• To reduce the risk of injury, close supervision is necessary
when the unit is used near children.
manufacturer.
• Do not put this product in water or other liquids.
Do not place the insect zapper where it can fall into water.
• Do not abuse the power supply cord or carry product by the
cord. Keep cable away from heat, oil, and sharp edges.
Never allow the cable to hang in front of the cover.
• Do not unplug by pulling on cord. To unplug, grasp the plug,
not the cord.
• Always disconnect the product from the power source when
not in use, before maintenance, and when cleaning.
• Always unplug before replacing the lamp.
• Store the unit indoors and out of the reach of children when
not in use.

INSTALLATION GUIDELINES

injury to yourself and others.
TO REDUCE THE RISK OF ELECTRIC SHOCK,
THE PLUG MUST BE PLUGGED INTO AN
APPROPRIATE OUTLET THAT IS PROPERLY
INSTALLED AND GROUNDED. CONSULT
A QUALIFIED ELECTRICIAN IF IN DOUBT
WHETHER PROPER GROUNDING EXISTS.
1.
zapper. Do not rest the unit on a surface without continuing
to support it. It will not stand on it's own.
2.
or explosive substances are likely to be present in the air.
3. Connect the appliance to main power.
4. The unit will be ON once it is connected to an electrical
source. There is no separate ON/OFF switch. The bulb will
take a few minutes to light up completely. The insect zapper
is designed for commercial usage such that the unit
could remain ON 24 hours a day.

PROPER GROUNDING

This item is provided with a three-pronged grounding plug.
The outlet to which this plug is connected must be properly
grounded. If the receptacle is not the proper grounding type,
contact an electrician. DO NOT, under any circumstances, cut
or remove the third ground prong from the power cord or use
any adapter plug.