MedGuard On the go Quick Setup Manual

www.MedGuardAlert.com
QUICK SET-UP GUIDE
STEP 1 – Set up and charge the
device
Connect Charger as shown in the
diagram to the right. NOTE: This device uses a
magnetic charging adapter. It will turn on,
indicating that the device is charging

For the first time use, please fully charge the
battery for approximately 2-3 hours.

While charging, the RED LED light will be on.

After fully charged the GREEN LED light will
light up.

Please note: Blinking RED LED light indicates
battery is low and needs to be charged.
Blinking GREEN indicates device is looking
for cellular connection
STEP 2 – Switching the device
on and off

To turn device ON: Press in and hold the
"HELP" button until device lights turn on.

To turn device OFF: Press and quickly release
your "HELP" button 3 times.

Please note: Device is designed to stay ON.
Should only be turned off if you are taking
your device on an airplane.
STEP 3 – Calling for Help

Press and hold the "HELP" button for at least 2
seconds. The device will announce "Placing
emergency call now."

To CANCEL a call: Press and hold the "HELP"
button for 2 seconds after call was made.
*Reminder: Device requires adequate
CHARGE YOUR DEVICE EVERY 24-48 HOURS.
battery charge and cellular signal to
make a call.
.
.
1125 Middle Street
Middletown, CT 06457
800-716-1433
STEP 4 – Please promptly complete and
return the enclosed forms to us
at:
MedGuard Alert, Inc.
1125 Middle Street
Middletown, CT 06457
Charger
Adapter