Table of Contents
Advertisement
that is most comfortable for you. The
indicator light will light up whenever
either of these switches are activated.
These switches control the water flow
to the carpet.
B. Cleaning Carpet
1. Turn vacuum switch on.
2. Position your machine for a cleaning
pass (fig. 18). Keep both your hands on
the machines handle.
3. How to make a cleaning pass. Turn on
one of the jets spray switches and walk
the machine backward. Work the hoses
with your feet. Apply enough upward lift
on the handle to keep the nose of the ma-
chine firmly on the carpet (fig.18).
4. At the end of your cleaning pass, turn
jet spray switch OFF and continue walk-
ing the machine backwards a few inches.
This will allow the machine to pick up
any excess moisture.
5. Reposition the machine for the next
pass (overlap approximately two to three
inches) and repeat steps three and four.
6. During your cleaning pass, if you
notice a lot of soap residue in the view
window, pull the defoamer switch up for
a second or more. If you ever hear the
RPM's of your vacuum motor decrease,
pull the defoamer switch up. This al-
lows defoamer to be drawn into the re-
covery tank and kill the soap suds.
IMPORTANT: Many carpets have tre-
mendous amounts of soap residue in
them. This machine is very efficient at
removing these residues. To protect your
vacuum motor from the soap suds that
can build up in your recovery tank, peri-
odically pull the defoamer switch up.
IMPORTANT: When using extra
hoses, hose reels, or really hot water,
your discharge pump may run hot and
Figure 14: Snapping in prespray hose
Figure 15: Prespraying carpet
Jet spray switches
Tube
connector
Figure 16: Control panel
Figure 17: Caddie with chemical
and prespray hose
-5-
Prespray
plug
Hose quick
disconnect
Prespray
hose
Dial-a-mix
sprayer
Vacuum switch
Defoamer
switch
Indicator light
Advertisement
Table of Contents
