KNOVA KN MR-78 Assembly Instructions page 2

METAL RACK KN MR-78
ITEMS YOU MIGHT FIND HELPFUL
Rubber mallet, gloves and wrench
CONTENTS
Description
A: Frame
B: Beam
C: Cross bar-A
D: Cross bar-B
E: Wire deck
F: Bolt nut washer
COMPONENTS
B: Beam
C: Cross bar-A
A: Frame
D: Cross bar-B
GENERAL INSTRUCTIONS
Assembly of this unit is done by fitting the brackets of the
beams into the slots of the post frames.
A rubber mallet should be used on the ledge of the beams
to properly seat the beam brackets. If a hammer is used
care should be taken to protect the beam surface to avoid
damage by using a protective cloth or block of wood.
The stepped surface of the beam ledge is the top, and
should face upwards. This is the surface that the wire deck
will rest on.
A bracket should engage and fit firmly into the tapered slot
of the post frame. This engagement is a tight swaged fit
and will apply resistance as it fully engages. A visual
inspection should be made to show that the bracket is
properly engaged in the slot.
After assembly re-check each beam for proper engagement.
SAFETY INSTRUCTIONS
This unit should be placed on a level surface. Failure to do so
can result in poor product performance or create a possible
safety hazard.
This unit should be securely anchored to a wall or floor with
suitable fasteners, which are not included.
Do not use this unit for anything
other than the manufacture's
intended purpose.
DO NOT STAND ON ANY
PART OF THE UNIT, OR
USE IT AS A LADDER.
Use care when working
with metal parts. Wear
gloves for protection.
Quantity
Evenly distribute the weight
on each level and always keep
2
the heavier loads on the bottom.
8
12
ASSEMBLY INSTRUCTIONS
4
• Attach the beams to the welded end frame posts
4
(see figure 1) starting at the bottom level by using both end
frames to establish the left and the right sides of the units.
8 set
• After a beam has been placed in both end frame post slots,
tap the beam down at both ends with a rubber mallet to
help drive the beam bracket tabs into the slots to secure
the beam. Continue assembling each level from bottom to
top level (front and back).
• If the beam bracket tabs become bent due to mishandling,
it may be necessary to adjust the tabs back to their proper
F: Bolt nut washer
form.
E: Wire deck
Install cross bar B in each level by inserting and tightening
the bolt, nut, washer into the holes located along the inside
both
• The completed unit should have four (4) levels evenly
spaced for maximum stability.
• Although the beams are adjustable in height, it's
recommended to evenly space them so that the stability
of the unit is not compromised.
• Install cross bar B in each level by inserting and tightening
the bolts, nuts, washers into the holes located along the
inside bottom center edge of the beams(see figure 2)
End frame post
Beam
bracket tabs
Figure 1
Beam