Table of Contents
Advertisement
Chengdu Ebyte Electronic Technology Co., Ltd.
recommended to configure the data transceiver to the normal mode (mode 0);
The factory default is normal mode (mode 0).
Categories
Mode
Normal
Mode 0
Mode
Mode 1
WOR Mode
Configuration
Mode 2
Mode
Mode 3
Sleep Mode
★Note: If there is no need for low power consumption, you don't need to care about the wake-up mode (mode 1) and power saving
mode (mode 2).
Copyright ©2012–2022，Chengdu Ebyte Electronic Technology Co., Ltd.
M1
M0
Open UART Comm port and RF，transparent
transmission is on, configuration over air via special
ON
ON
command is available.
Can be defined as WOR transmitter and WOR receiver，
ON
OFF
WOR is available.
Users access the register through the serial port to control the
OFF
ON
working state of the device. The DTU can be configured
through the configuration software on computer.
OFF
OFF
DTU is in sleep mode.
E32-DTU(433L33)-V8 User Manual
Notes
11
Advertisement
Table of Contents
