Table of Contents
Advertisement
20
Note: The Post Processing screen will first check if the
connected receiver is the RTK base or rover. If you are
connected to the RTK base or rover receiver, your only option
here is to stop recording. To start recording with the base or
rover receiver, use RTK setup described in the previous
section.
If the connected receiver is already recording data, you can
tap Stop Recording to end logging and close the file.
Post Processing Data Collection
After recording is started, the Static Receiver Session screen
is opened. You can also access this screen by going to the
Survey > Data Collection menu and choose to connect to a post
processing receiver. Use the following controls for post
processing data collection:
Store Point In:
Receiver and job file will mark the event in the post
processing logging file, and store a point in the Survey
Pro job. You can use this mode to save attribute or
layer information in the Survey Pro job file.
Receiver file only will only mark the event in the post
processing logging file. In this mode, the Site ID does
not need to be a unique point name, and nothing is
stored in the Survey Pro job file. A note record is
made for this occupation in the Survey Pro raw file.
NOTE: By default, post processing points are stored in the
Survey Pro job file are put on a special layer to distinguish
them from other data collected points. Points stored in
Survey Pro job file will have a plane coordinate of (0,0,0) and
a geodetic coordinate from the receiver's autonomous position.
Session Duration:
Enter 0 or check Log Until Stop to have this session
run until you tap Stop.
Advertisement
Table of Contents
