Download Print this page

BONA SPES VIKING SP16W Instructions For Use page 2

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 2
EN
VIKING SP16W 16000mAh - Instruc�ons for use
Thank you for choosing a VIKING product.
Please refer to the technical specifica�ons of each model in the user manual or on the website www.best-power.cz
Method of use:
Please check that the device is fully charged before each use of the power bank. The capacity and charging status
will be shown on the display when the power bank is started.
Power on/off
- To switch on the power bank, briefly press the "ON/OFF" bu�on. When switched on, the display will light up and
show the ba�ery capacity status.
Charging the solar power bank with solar energy:
- Make sure that the solar panel faces directly towards the sun.
- Charging will start automa�cally.
- The maximum power of the solar panels is 8W.
- The power of the solar panel depends on the intensity of the solar light.
- The sun icon on the display indicates solar charging
- The power bank con�nuously recharges its capacity even in ar�ficial light and indirect sunlight, but with reduced
power.
Charging the solar power bank from an external power source:
- The power bank can be charged using a cable with a USB-C or micro USB connector.
Charging other devices:
- Connect the power bank to the device being charged.
- Mul�ple devices can be charged at once.
- Charging starts automa�cally.
- If charging does not start automa�cally, turn on the power bank manually.
Using wireless charging
- Make sure that the device you are charging supports wireless charging.
- Turn on the power bank before using wireless charging.
- Place the device to be charged on the back of the power bank in the area marked for wireless charging.
- The device to be charged should not be more than 8mm from the power bank.
- Charging will start automa�cally. The LED on the back of the power bank will light up.
- If the LED on the back is not lit, wireless charging cannot be used. Either the charged device is fully charged, or a
foreign object is preven�ng wireless charging, or the charged device is incorrectly posi�oned on the powerbank.
LED flashlight control:
- Press and hold the "ON/OFF" bu�on un�l the LED light turns on. Addi�onal short presses to toggle between the
LED light modes (1. Steady light, 2. Dimmed light, 3. SOS light, Strobe, LED light off) and hold the "ON/OFF" bu�on
to turn the LED light off.
No�ce:
1. It is common for the body of the backup power supply to heat up during charging and gradually reduce its
temperature to room temperature a�er charging is completed.
2. If you have not used the device for more than 90 days, store it charged to 75% capacity. This will prevent
damage to the ba�ery.
WARNING
1. Do not disassemble the product or its accessories.
2. Do not modify, disassemble, open, puncture or otherwise tamper with the ba�ery located inside.
3. Protect from fire, prolonged direct sunlight and other heat sources to prevent overhea�ng and damage to the product including the ba�ery located inside.
4. Protect from contact with water and wet objects, especially when using the product.
5. Protect from high voltage devices.
6. Do not throw or shake the backup power source.
7. This unit has a built-in non-removable rechargeable ba�ery. Do not a�empt to remove the ba�ery
remove the ba�ery to avoid damaging the device.
8. Do not use chemical cleaning agents to clean the product.
9. This device is not intended for use by persons (including children) whose physical, sensory or mental incapacity or lack of experience or knowledge prevents them from using the
device safely. Protect from children!
10. When not in use, secure the sockets with safety plugs.
11. Stop using this equipment immediately if the product is damaged in any way.
12. Use the original power adapter and other accessories for charging.
13. In case of igni�on, do not use a water ex�nguisher!
Ignoring the following safety instruc�ons may result in fire, electric shock, or damage to the generator.
Statement:
Do not dispose of the product or ba�eries at the end of their useful life as unsorted municipal waste, use sorted waste collec�on points.
For more informa�on on recycling this product, contact your local municipality, household waste management organiza�on or the point of
sale where you purchased the product.
The product is guaranteed for 24 months from the date of sale, including the ba�ery.
The ba�ery life is 6 months, when under normal and proper use, the ba�ery's real (rated) power will not drop below 80% of the ba�ery's
rated power.
LED life�me is 6 months, where under normal and proper use of the LED lights, a minimum of 80% of the total number of LEDs in the device
are guaranteed to be lit.
Loss of warranty:
Warranty is void in the event of the condi�ons listed below:
- Damage due to improper use, or use under unsuitable condi�ons.
- Failure to comply with the technical specifica�ons of the equipment.
- A�empt by the user to make an unprofessional repair or disassembly.
- The equipment or any part of it is damaged due to natural elements, e.g. lightning, water,
mechanical damage, etc.
- The equipment or any part of it is damaged due to unprofessional handling.
BONA SPES s.r.o., Řepčín 250, Olomouc 77900, Czechia, IČO: 03476774, DIČ: CZ03476774, VAT No.: 03476774,
Distribu�on of the VIKING and TOPDON brands is provided by the company:
+420 777 109 009, www.best-power.cz, info@best-power.cz
Model
SP16W
Capacity
16000mAh/59Wh
3.7V
Type
Li-lon
Service life
min. 500 full charge cycles
Inputs:
USB-C PD2.0
5V/3A, 9V/2A
Micro USB
5V/2A, 9V/2A
Outputs:
USB-A QC3.0 2x
5V/3A, 9V/2A, 12V/1.5A
USB-C
5V/3A, 9V/2.22A, 12V/1.67A
Wireless (wireless charging)
10W
Solar panel
8W
Product dimensions
180x91x33mm
Mass
680g
Material
IP64
Accessories
micro USB cable
CE, FCC, RoHS
0~50°C
1. USB-A output
2. USB-A output
3. USB-C output/input
4. Wireless
5. Micro USB input
6. LED display
7. "ON/OFF" bu�on
8. Solar panels
9. LED light
10. Wireless LED diode
BONA SPES s.r.o.
More informa�on
about the product

Advertisement

loading