landscape structures Stand-Up Seesaw Maintenance

Fasteners
Tighten attachment fasteners. Re-
place if cracked, deformed or bro-
ken.
General Materials/Finishes 1
Refer to the General Cleaning/Re-
pairing Instructions found in the
"Freestanding Play System Play-
ground Maintenance Sheet."
Bushings
Replace if mechanism binds or
metal-to-metal contact is noted.
Bolt Covers
Replace if plastic is cracked, brittle
or seriously discolored.
Surfacing
Surfacing should cover the base
of the seesaw with a 2"- 4"depth
and be level throughout the area.
(Please see Leg Attachment De-
tail) Warning: The seesaw de-
pends on correct surface height to
stop excessive movement. Ne-
glecting surfacing will lead to pre-
mature polyurethane rod failure.
Polyurethane Rod
Replace if the Stand-Up Seesaw
pivots freely and lacks resistance.
Seesaw Assembly
Replace if welds are broken, or if
the assembly is deformed, or pit-
ted with rust. Repair damaged
powdercoating per instruction
sheet.
Base Assembly
Replace if welds are broken, or if
the assembly is deformed, or pit-
ted with rust. Repair damaged
powdercoating per instruction
sheet.
© 2012 by Landscape Structures.
Stand-Up Seesaw
1
1
1
Stand-Up
Seesaw
Assembly
1
Base
Assembly
1
2
2"-4"
Surfacing
2
Leg
148881-00
Leg
Replace if welds are broken, or if
the assembly is deformed, or pit-
ted with rust.
J:\SPECS\185\18577500.P65
DETAIL
LEG ATTACHMENT
Base Assembly
156257-00
(4)
Hex Nuts
129692-00
2
NOTE: Surfacing must be
maintained between 2"-4"
above the bottom of the
base.
Freestanding Play
Document #18577500
(4) 1 / " x 1 1 / " Hex
2 4
Cap Screws
100216-00
1
(4) / " Flat
2
Washers
100363-00
1
(4) / " Flat
2
Washers
100363-00
1 / " Standard
2
Sheet 1 of 2