New 11/19/19
Made in China • Printed in China
IMPORTANT INFORMATION
1. Operating time for your
depends on continuous or intermittent use. Intermittent operation
extends the run time of the battery.
2. The LED is a lifetime light source. It will never need to be replaced.
3. It is normal for the flashlight's aluminum body to get very warm during
continuous use.
WARNING! Do not disassemble product. Do not charge the battery if the
product / battery is cracked or damaged. Do not short terminals, crush,
heat above 140 Degrees F. (60 Degrees C.), throw into a fire, or incinerate.
Please recycle.
ONE YEAR LIMITED WARRANTY
This Bushnell® product is warranted for a period of 1 year from the original date of purchase
against any defects in materials or workmanship. At the discretion of the manufacturer, they
may provide replacement parts to original purchaser. Original receipt or proof of purchase,
as well as confirmation of the defect is required. The manufacturer will not be responsible
for shipping costs incurred outside the continental USA. Warranty is valid for the original
purchaser one year from the date of purchase and is not transferable. This warranty does
not cover any product purchased through non-authorized dealers and/or online auction
websites.
This Warranty Does Not Cover
This 1 Year Limited Warranty does NOT cover normal wear and tear, abuse or misuse of this
product.
All replacement products or parts will assume the remaining warranty of the original
product. This warranty gives you specific legal rights. You may also have other rights which
vary from state to state.
Manufactured and distributed under license from Bushnell Inc. Overland Park, KS 66214 by
Insight 2 Design, LLC. Overland Park, KS 66223.
To Obtain Warranty Service
Call Toll Free 1-888-774-5840 for warranty service or product questions.
Mon-Fri, 8:00 a.m. - 5:00 p.m. Central Time
© 2019. Bushnell is a trademark of Bushnell Inc. Trademark is used under a Trademark License
Agreement by Insight 2 Design, LLC. Overland Park, KS 66223.
Insight 2 Design, Inc., Overland Park, KS 66223
Bushnell® 2000 Rechargeable
Flashlight
Need help?
Do you have a question about the 2000 Rechargeable and is the answer not in the manual?
Questions and answers
I also have a flash light that on and off button doesn’t work
The Bushnell 2000 Rechargeable Flashlight uses a Button Switch for operation. If you are experiencing issues with turning it on or off, try the following steps:
1. Ensure Proper Button Operation:
- For *Momentary-On*: Press the button halfway and hold for High mode. Quickly press halfway twice and hold for Low mode.
- For *Constant-On*: Press the button fully once for High mode, press fully again to turn off. Press fully a third time for Low mode.
2. Check Battery Charge:
- If the flashlight does not turn on, recharge it for at least 8 hours using a Micro-USB cable.
- Ensure the indicator light turns from red to green to confirm a full charge.
3. Inspect for Damage:
- Do not use the flashlight if the battery or body is cracked or damaged.
- If the button is stuck or unresponsive, avoid disassembling the flashlight.
4. Warranty Service:
- If the button is still unresponsive, contact Bushnell's warranty service for possible replacement within one year of purchase.
If the issue persists, consider professional repair or replacement.
This answer is automatically generated
Can the on/off button be replaced