Tool Operation & Set-Up; Transportation & Storage - Greenlee Reel-X FTXF-50 Instruction Manual

Fish tape
Hide thumbs Also See for Reel-X FTXF-50:
Table of Contents

Advertisement

Tool Operation & Set-Up
Do not use fish tape near live circuits. Contact with
live circuits could result in severe injury or death.
Always wear safety glasses and gloves when
using this tool. Injury could result from sharp edges
or from the pulling eye wipping around if the the fish
tape leaves conduit suddenly.
Do not use fish tape above rated load or use
powered pulling equipment. Overloading fish tape
could result in the tape breaking and may cause
striking or falling injuries.
Do not pull using the housing, only pull on fish
tape material. The tape may break or pull from the
housing.
1. Prepare an appropriate work area free of obstructions
or hazards.
2. Check the storage lock is unlocked before fishing.
(Figure 1)
3. Manually feed the fish tape through the conduit. Hold
the housing securely with one hand while feeding with
the other, if using the Primary Exit.
If using the Secondary Exit (Fiberglass Only) lay the
case flat on the ground with one foot keeping it in
place while pulling straight up using both hands to
feed tape.
Do not force tape that is jammed or not moving.
Remove fish tape and check for kinks and obstructions
before trying again.
4. Fasten the pull line or wire securely (Figure 2). For
additional security, wrap the pulling end with electrical
tape (Figure 3).
5. Pull fish tape back through conduit. Keep a stable
stance to prevent falling from the tape exiting conduit
suddenly. Do not pull using the housing or when the
lock is engaged. Do not pull fish tape over sharp
edges or corners.
6. Pull out desired amount of wire or line from the
counduit. Remove tape around the connection and
separate wire/line from pulling eye.
8
1.800.544.2843
7. Feed the remainder of the tape onto the reel, stopping
8. Engage the lock on the reel to secure the tape for
Transportation & Storage
Keep storage lock in the locked position and the pulling
eye secure with a zip tie or equivalent when not in use.
This keeps the fish tape from unwinding from excessive
vibration and shock when transporting or from the stored
tension in the fish tape when left alone in storage.
www.calcert.com
15
10
20
5
25
0
30
Reel-X
so just the pulling eye is out of the case for use on the
next job.
transport to the next site or storage. Secure pulling
eye if fish tape is going into storage.
Eye Fitting
Figure 1
sales@calcert.com
Fish Tape
Figure 2
Line or Rope
Figure 3

Advertisement

Table of Contents
loading

Table of Contents