whisker Litter-Robot 4 Installation Manual

Installing the
Li er-Robot 4
Carbon Filter
Li er-Robot 4 is equipped with a flexible carbon
lter pad that is installed on the outer bo om area
of the globe. This lter sits directly over the waste
drawer to absorb odours. (The carbon lter is not
required for the unit to function.)
1
Press and hold the Cycle and Empty
bu ons on the control panel for 3 seconds, or
tap "Replace Filter" under Controls in the app.
4
Open the lter cover and replace the carbon
lter as needed. (Under normal use, 1 lter
should last approximately 1 month.)
LR4-8092
2
A clean cycle will begin; the cycle will pause
when the globe reaches the "replace lter"
position.
5
Close the bonnet: Rotate the bonnet down-
ward over the globe and push down on the
bonnet from the top to make sure it is
latched and secure.
Installation guide
How to install
3
Open the bonnet: Press and hold the latches
on both sides of the bonnet, then li and
rotate the bonnet to its open position to
reveal the lter pocket.
6
Press the Cycle or Reset bu on to
resume the clean cycle; when the clean cycle
has ended, press the Reset bu on to zero the
weight sensors.
Questions? Visit whiskersuppo .com