CAUTION FOR SAFETY NAME OF EACH PART AND SPECIFICATION [ NAME OF EACH PART ] *Read the "CAUTION AND SAFETY INSTRUCTION" carefully before use. The following cautions are shown for the proper use of this product to protect you and others from danger or harm. The following contents explains the possible danger or damage which may occur through inappropriate use.
BEFORE USE BEFORE USE How to Use the Hose Reel Adjust the length of the 2-step extensible nozzle pipe. (Max. 109 cm, Min. 62 cm) Rotate the tightening part to loosen the pipe. Adjust the length and rotate again to fix the This product employs the traverse mechanism for the hose reel so the hose can easily be pipe.
Page 5
BEFORE USE BEFORE USE How to pull out the hose How to reel the hose There are 2 methods for pulling out the hose. Rotate the handle clockwise when seeing the handle in front. Then, reel the hose. • Set the hose guide to the free state to pull out. •...
Page 6
BEFORE USE BEFORE USE How to Use the Tire Stopper and Brake Rotating direction of the handle The hose is reeled clockwise when Tire Stopper Tire Stopper the handle is seen from front. Caution Do not rotate counterclockwise. The tire direction can be fixed when the tire Doing so will cause the hose to stopper pin is pulled as shown below.
HOW TO USE BEFORE USE Fuel / Engine oil Starting Engine 4 stroke engines need both fuel and engine oil. 4 stroke engines need both fuel and engine oil. 4 stroke engines need both fuel and engine oil. 4 stroke engines need both fuel and engine oil. 4 stroke engines need both fuel and engine oil.
Page 8
HOW TO USE HOW TO USE Set pressure adjusting handle at Start "O". Start engine and adjust throttle lever to accelerate revolution until high speed. Check if liquid is spraying from spray head. After checking the machines condition, turn pressure adjusting handle and set "L", "M", or "H"...
HOW TO USE HOW TO USE Spraying How to Stop By operating the handle grip, you can select either the consecutive spraying or the Disengage the handle grip lever to stop intermittent spraying. spraying. Release Intermittent spraying Consecutive spraying *When using the lever lock, cancel the lock. With the lever lock canceled, use The consecutive spraying is possible using Lever lock...
Page 10
CAUTION AFTER USE CAUTION AFTER USE Spray clean water for 2-3 minutes to wash out chemicals from inside of pump, hose and Remove dirt from engine, pump, nozzle, etc. If moisture is left, engine gets rusty and it may nozzle after use. cause trouble.
Page 11
TROUBLE AND MAINTENANCE CAUTION AFTER USE Check before ask service station. Washing Spray Head Symptom Possible Cause Maintenance Cannot pull Cannot pull Change fuel. If it is still in bad Vertical 2-head spray mouth Engine trouble due to use of oil fuel recoil starter recoil starter condition, ask service station.
Page 12
TROUBLE AND MAINTENANCE TROUBLE AND MAINTENANCE MAINTENANCE 2 MAINTENANCE 2 Symptom Possible Cause Maintenance Low spray Low spray Air is coming into suction side Check suction pipe Check suction side pipe volume Bad volume Bad * See "Maintenance 2" If suction does not start or spray volume is less, the major possible cause is that condition of condition of Decline of engine output...
Page 13
Check parts list for Koshin products from Koshin website. Order parts from the shop where you bought the machine. Check parts code and parts name before ordering. http://www.koshin-ltd.jp/english/ For other parts, go to KOSHIN website to see full parts list. Parts Parts Code Parts Name Click banner "Parts List"...
Need help?
Do you have a question about the KV-EX50TH85 and is the answer not in the manual?
Questions and answers