Table of Contents
Advertisement
Cob
1
Cobra
®
AN8630-25
WALL MOUNTING
On A Plate
Your Cobra Intenna is designed to be used
with AT&T, GTE or any other wall-mounting
plates that may be purchased from most
local electronics or home repair stores.
1. Press the telephone cord into the slots
under the base and wrap it around the
cord storage area as shown.
2. Plug the phone connector into the
telephone wall jack.
3. Plug the power adapter into the
telephone base and a nearby AC power
outlet.
4. To hang the phone base, simply align
the holes on the bottom of the base with
the studs on the wall plate and slide the
base down until it locks into place.
5. To hang up handset, pull cradle hook to
1
down position.
CRADLE
HOOK
Directly On The Wall
To install the base directly on any wall, you'll
need two screws and wall anchors (not
included).
1. Drill two holes aligned vertically, one
31⁄4" higher than the other, and insert
the wall anchors.
2. Drive the screws into the anchors until
the head of each screw sticks out about
1⁄8" from the wall.
3. Plug the phone connector into the
telephone wall jack.
4. Plug the power adapter into the
telephone base and a nearby AC power
outlet.
5. To hang the phone base, simply align
the holes on the bottom of the base
with the screws on the wall and slide
the base down until it locks into place.
6. To hang up handset, pull cradle hook to
1
down position.
CRADLE
HOOK
2
Cobra
®
USING YOUR PHONE
Now that the handset batteries have
charged overnight (at least 12 hours) your
Cobra Intenna Cordless Phone is ready to
use.
To Answer A Call At The
Base
2
When the phone rings, simply pick up
TALK
the handset from the base and the
TALK button will automatically light.
When you hang up the handset in the
base, it disconnects.
To Place A Call At The Base
2
Pick up the handset from the base,
TALK
then press and release the TALK button.
When you hear the dial tone, place your
call.
To Answer or Place A Call
Away From The Base
2
The TALK button must be off (not lit)
TALK
when the handset is away from the
base and not in use. Press and release
the TALK button and, when your
conversation is finished, press the TALK
button again to disconnect. If you
replace the handset in the base, the
TALK button will disconnect
automatically.
Note: Some cordless telephones
operate at frequencies that may cause
interference to nearby TV's and VCR's.
To minimize or prevent such
interference, the base of the cordless
telephone should not be placed near or
on top of TV's or VCR's. If interference is
experienced, moving the cordless
telephone base further away from the
TV or VCR will often reduce or eliminate
the interference.
?
1-773-889-3087
NEED HELP
1
Advertisement
Table of Contents
