1. Manuals
  2. Brands
  3. DATAGRABBER Manuals
  4. Data Loggers
  5. RapidRH L6 with Bluetooth
  6. Instruction manual

DATAGRABBER RapidRH L6 with Bluetooth Instruction Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual

Advertisement

Table of Contents
loading

Related Manuals for DATAGRABBER RapidRH L6 with Bluetooth

Summary of Contents for DATAGRABBER RapidRH L6 with Bluetooth

  • Page 2: Table Of Contents

    Total Reader as the Bluetooth conduit to the DataMaster L6 app. By using a DataGrabber to enable an L6 sensor to store up to 512 RH and temperature readings on a time and date-stamped...

  • Page 3: Datagrabber ® With Bluetooth

    Rapid RH L6 Smart Sensors and transmits the data to the free DataMaster L6 app. Snap the DataGrabber with Bluetooth into an L6 Smart Sensor, then use the DataMaster L6 app to set up time...

  • Page 4: Connect

    (see Troubleshooting section). In approximately 20 seconds or less, the Device Settings screen for that DataGrabber will appear; see below. Next, click on the Menu icon located in the upper right-hand corner of the screen.

  • Page 5: Troubleshooting

    RH and synchronize to the clock on your mobile device. temperature. For instance, setting an acclimation time of one day and then starting, the DataGrabber will wait 24 hours and “grab” a measurement for storage in the L6 Smart Sensor’s TROUBLESHOOTING memory.

  • Page 6: Removal

    1. Carefully remove the screws near the top with a small Phillips head screwdriver. 2. Tip the DataGrabber with Bluetooth upside down and tap the bottom of the unit carefully to dislodge the battery into your palm. 3. Place the battery within the well positive side up. (Note: the battery text should be visible.)

  • Page 7: Datagrabber

    Insert the DataGrabber into the L6 Smart Sensor as shown and use the Total Reader to connect to the DataMaster L6 app on your mobile device. The DataGrabber will appear on the DataMaster L6 Devices screen, as named, along with any DataGrabbers with Bluetooth capability.

  • Page 8: Data Collection

    DataMaster L6 app’s Devices screen. The screen displays devices in order according to greatest signal power. Therefore, the DataGrabber should be at the top of the list of devices, since you will most likely be holding the Total...
  • Page 9 Start and Stop: After you have saved the desired settings and are ready to begin data logging, click the Start button to signal to the DataGrabber to begin the acclimation time. Time and date-stamped data logging begins as soon as the acclimation time is completed.

  • Page 10: Removal

    WAGNER METERS REMOVAL BATTERY Removing and Replacing the Battery To remove the DataGrabber, use the included removal tool as shown to carefully extract DataGrabber without damaging the unit. 1. Carefully pry open the battery compartment cover with a small flat head screwdriver or similar device.
  • Page 11 326 Pine Grove Road Rogue River, OR 97537 Worldwide Toll-Free: (888) 266-7756 The RAPID RH L6 DataGrabber is registered ® under U.S. Patent 9032791 ©Wagner Meters 2019 All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of the publisher.

Table of Contents