TSPD-01
TURN RUBBER ROLLER TO
ADVANCE AROUND 1/2" OF
TAPE ONTO FINGERS
1
PLACE DISPENSER ON BOX
WITH HANDLE PARALLEL TO
SURFACE & PRESS
1
*
PLEASE NOTE: After using Zippy the 'two handed'
way for a while, you'll probably use it 'one-handed'
most of the time.
There are many variables while taping; the particular
USE 'ONE HANDED' OR 'TWO HANDED' OR ANY COMBINATION *
PULL OUT MORE TAPE
AND PLACE ONTO BOX
2
WHILE PRESSING, ROLL TAPE
ONTO BOX
2
tape and box you're using, size of the box, your
position relative to the box, box or other item such as
envelope, personal preference, etc. - so, you'll probably
enjoy the fact that Zippy was designed to be used in
many possible ways to suit your needs.
PRESS DOWN AS YOU
ROLL TAPE ONTO BOX
3
OR
KEEP ON ROLLING
3
- - PLEASE SEE OTHER SIDE - -
HOLD TAPE IN PLACE
4
PRESS TAPE FIRMLY TO BOX
(MAKE SURE IT STICKS WELL)
4
Dust: Keep your rubber roller free of dust by following
instructions (see other side) to clean periodicaly. If
using with dusty boxes, you can prevent dust from
reaching roller by starting with #1, top left - turn
rubber roller... before continuing either 'one' or 'two
handed' .
WHILE HOLDING TAPE TO BOX,
LIFT DISPENSER UP GENTLY
TO CUT
5
CONTINUED
LIFT GENTLY TO CUT
5