Failure to comply with instructions could result in personal injury and or property damage. Please keep these instructions for future reference. Introduction Page Water Happens………………………………………………………………………………………………………………………………………………….01 The HydraPump Smart Duo.…………………………………………………………………………………………………………………………... 01 Arrival And Inspection………………………………………………………………………………………………………………………………….. 01 Safety First Handling the Pump…………………………………………………………………………………………………………………………………..…... 02 While Pumping…………………………………………………………………………………………………………………………………………………..02 Key Considerations………………………………………………………………………………………………………………………………………….
• 1pc. Outlet from 1 ¼ “ NPT to GHT thread, and an included check valve • 1pc. Hoisting rope for positioning the pump • 1pc. Manual packet There are circumstances where the pump or its parts can become damaged during shipping. If damaged during shipping, please contact Watershed Innovations customer service.
Safety First! Safety Information This manual contains information that is very important to read and understand. Information provided is for safety purposes and to prevent equipment problems. The following symbols are used to help identify safety issues and their potential impact. This indicates a potentially hazardous situation, which MAY result in moderate injury.
Key Pumping Considerations 1. A 120V AC power source is required for the HydraPump® Smart Duo to operate. It must be a Ground Fault Circuit Interrupter (GFCI) device connection. 2. The circuit breaker and outlet must be properly grounded before installing this pump. If you have questions about this, or are unsure, have the electrical circuit checked by an electrician.
Setting UP INstallation and Operation Installation 1. Attached Hoisting Rope (if desired) - In order to adjust the position of the pump on a surface like a pool cover the included hoisting rope can be attached to the front loop of the pump.
Manual Operation To operate the pump in manual mode simply turn the front switch to ʻManualʼ and the pump will begin pumping immediately. Note: Do not let the pump run without pumping water. This may cause the pump to stop working . Adapter Connections The pump adapter allows for a ¾”...
Cleaning & Maintenance Impeller Cleaning Always disconnect the power source before attempting to clean the impeller. 1. Unplug the pump. 2. Remove the screws shown in the figure. 3. Remove the cover and carefully clean the impeller of all debris. 4.
Draining For Storage A er pumping is complete, disconnect the garden hose or other piping from the pump. Empty and remove the outlet hoses. Wipe the pump clean and store in a clean and dry place for next use. The pump may become hot during operation. Be careful when working near or touching the pump.
More Information Specifications These are the technical specifications for the HydraPump® Smart Duo: • ¼ HP Output Power, Single Phase 120V, 60Hz, 3.4A Max • Pumping Capacity 1,600GPH Max • Maximum Head 20 Troubleshooting PRoblem Possible Causes SOlutions No Power or cord not connected Check outlet power or plug in pump GFCI tripped...
About Watershed Innovations Watershed Innovations was founded in 2008 with the goal of creating user-friendly products that protect valuable property and land from water damage. Our flagship product was born out of necessity when one of our founders struggled with his backyard pool overflowing during Californiaʼs rainy season.