Do you have a question about the I 48 and is the answer not in the manual?
Questions and answers
agostinho degouveia
April 10, 2025
I have 2 modules that feed 2 rows of T5 florescent strip lights. when both are on one row will do a slow strobe, when i turn off the good row the bad row will work just fine
1 comments:
Mr. Anderson
April 10, 2025
A slow strobe effect in one row of T5 fluorescent strip lights using Colortran I 48 modules could be caused by several issues:
1. Improper Dimming Compatibility: T5 fluorescent lights require specific dimmable ballasts that are compatible with the dimming system. If the ballast is not compatible with the Colortran I 48 module, it may cause flickering or a strobe effect.
2. Low Voltage Signal Issues: The Colortran I 48 is a dimming system that typically uses a low-voltage control signal. If the signal is unstable or distorted, it may cause inconsistent dimming behavior in the lights.
3. Ballast Problems: A failing or incompatible electronic ballast in that specific row could cause the lights to flicker or strobe. Ballast degradation can create irregular current output, leading to visible flicker.
4. Wiring Issues: Loose, damaged, or improperly connected control or power wiring to the affected row can cause voltage drops or intermittent signals, resulting in a slow strobe effect.
5. Control Module Fault: The specific channel or output on the Colortran I 48 module controlling that row may be malfunctioning, delivering an unstable or incorrect signal.
6. Electrical Interference: Nearby electrical equipment or poor grounding may introduce noise into the system, leading to flickering behavior in sensitive fluorescent fixtures.
To fix the issue, verify ballast compatibility, inspect wiring and connections, test the dimmer module output, and consider replacing faulty components.
Need help?
Do you have a question about the I 48 and is the answer not in the manual?
Questions and answers
I have 2 modules that feed 2 rows of T5 florescent strip lights. when both are on one row will do a slow strobe, when i turn off the good row the bad row will work just fine
A slow strobe effect in one row of T5 fluorescent strip lights using Colortran I 48 modules could be caused by several issues:
1. Improper Dimming Compatibility: T5 fluorescent lights require specific dimmable ballasts that are compatible with the dimming system. If the ballast is not compatible with the Colortran I 48 module, it may cause flickering or a strobe effect.
2. Low Voltage Signal Issues: The Colortran I 48 is a dimming system that typically uses a low-voltage control signal. If the signal is unstable or distorted, it may cause inconsistent dimming behavior in the lights.
3. Ballast Problems: A failing or incompatible electronic ballast in that specific row could cause the lights to flicker or strobe. Ballast degradation can create irregular current output, leading to visible flicker.
4. Wiring Issues: Loose, damaged, or improperly connected control or power wiring to the affected row can cause voltage drops or intermittent signals, resulting in a slow strobe effect.
5. Control Module Fault: The specific channel or output on the Colortran I 48 module controlling that row may be malfunctioning, delivering an unstable or incorrect signal.
6. Electrical Interference: Nearby electrical equipment or poor grounding may introduce noise into the system, leading to flickering behavior in sensitive fluorescent fixtures.
To fix the issue, verify ballast compatibility, inspect wiring and connections, test the dimmer module output, and consider replacing faulty components.
This answer is automatically generated