Related Manuals for Rok 150-67-50594
Summary of Contents for Rok 150-67-50594
- Page 1 INSTRUCTION MANUAL 150-67-50594 1200W 180MM POLISHER Warning: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE Made in China...
- Page 2 General power tool safety warnings WARNING Read all safety warnings, instructions, illustrations and specifications provided with this power tool. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool"...
- Page 3 d) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. e) Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations.
- Page 4 BUFFER POLISHER SAFETY WARNINGS WARNING! Hold power tool by insulated gripping surfaces, because the pad may contact its own cord. Cutting a “live” wire may make exposed metal parts of the power tool “live” and could give the operator an electric shock. This power tool is intended to function as a polisher.
- Page 5 Never lay the power tool down until the accessory has come to a complete stop. The spinning accessory may grab the surface and pull the power tool out of your control. Do not run the power tool while carrying it at your side. Accidental contact with the spinning accessory could snag your clothing, pulling the accessory into your body.
- Page 6 ASSEMBLY 1. Install the auxiliary handle. For your personal safety we recommend using the auxiliary handle at all times. The auxiliary handle with help you grasp your tool more firmly. The auxiliary handle can be installed on either the right or the left side of the tool. Secure the handle with the hex key and tighten firmly. Always hold your polisher firmly with both hands when operating.
- Page 7 4. Inspect electrical cords periodically, if damaged have it repaired or replaced by a qualified technician or a power tool service center. 5. The brushes should be checked periodically, and worn-out brushes should be replaced. After replacing, inspect whether the new brushes can move freely in the brush holder 6.
- Page 8 Benchtop machinery – 12months from date of purchase Trade and commercial use: • 6 months on all ROK products. This guarantee covers material and workmanship defects only. In order for the guarantee to be acted on, the consumer must use the products strictly in accordance with their operating manual and for the purpose for which they are intended to be used.
Need help?
Do you have a question about the 150-67-50594 and is the answer not in the manual?
Questions and answers