Table of Contents
Advertisement
Advertisement
Table of Contents
Summary of Contents for PRO STORMER CD08-2120
- Page 1 CD08-2120...
-
Page 2: Electrical Safety
Drill warnings: WARNING: Read all safety • Do not expose power tools to rain or wet conditions. Water entering warnings and all instructions. a power tool will increase the risk Failure to follow the warnings of electric shock. and instructions may result •... - Page 3 protection used for appropriate switch does not turn it on or conditions will reduce personal off. Any power tool that cannot injuries. be controlled with the switch is dangerous and must be repaired. • Prevent unintentional starting. Ensure the switch is in the off- •...
- Page 4 pack into power tools that have • Hold power tools by insulated the switch on invites accidents. gripping surfaces when performing an operation where • Recharge only with the charger the cutting tool may contact specified by the manufacturer. A hidden wiring or its own cord.
- Page 5 • Position the cord clear of rotating accessory. Accessories may be bit. Do not wrap the cord hot after prolonged use. around your arm or wrist. If you • Do not run the drill while carrying lose control and have the cord it at your side.
-
Page 6: Battery Warnings
Battery warnings: • Before using battery charger, read • Do not recharge battery in damp all instructions and cautionary or wet environment. Do not markings on battery charger, expose charger to rain or snow. battery pack, and product using If battery case is cracked or battery. - Page 7 of electric shock. Removing the exposed to spark or flame. battery pack will not reduce this • Charge the battery packs only in risk. the charger which accompanied • The charger is designed to your product. operate on standard household DO NOT splash or immerse in •...
-
Page 9: Charging A Battery
Charging a battery WARNING: Place the battery pack and charger on a flat non-flammable surface and away from ammable material when re-charging the battery pack Insert the plug on the charging unit into a power socket and turn the power on if required. -
Page 10: Using Your Drill
Using your drill IMPORTANT: Before starting inspect your drill bit to ensure there is no excessive wear and that it is sharp. Never use a drill bit if it is damaged or blunt. Check that the drill bit is correctly fitted in the chuck and is the correct type for the material you wish to drill a hole in. - Page 11 Battery technical specification 12 V DC 2000mAh Li-ion battery pack Battery pack Charging time 1 hour Charger adapter input 100-240V AC 50-60Hz Charger adapter output 13.5V DC 2.2A Drill technical specification Rated voltage No Load speed 0-400/0-1400rpm Max. torque 28 Nm Chuck capacity 0.8 to 10mm Torque setting...
Need help?
Do you have a question about the CD08-2120 and is the answer not in the manual?
Questions and answers