Subscribe to Our Youtube Channel
Summary of Contents for Recoil RB1
- Page 1 WATERPROOF BLUETOOTH CONTROLLER Recoil IPX7 Waterproof Bluetooth Controller User Manual...
- Page 2 The RB1 controller has a DIN plug. This plug can be connected directly to the Recoil Powersports amplifiers. Remote power trigger- ing: The RB1 is able to power Recoil amplifiers. whenever you turn the RB1 ON or OFF the amplifier will follow the same.
- Page 3 (Should not be used) The remote-in is an extra feature we added to the RB1. You should NOT use this wire unless your RB1 controller is hooked up to another source unit. So, when that source unit is turned on/off, RB1 will be turned on/off also automatically.
- Page 4 Search for (RB1)device. On phone select (RB1) to pair device. Once a device is paired each time this device is seen by the Recoil RB1, it will automatically reconnect to the device. If no device is present the Recoil RB1 automatically goes into pairing mode and will present itself as discoverable for the next device present.
- Page 5 STEP 1: Slide the RB1 cables through the Flush mount plate and screw the plate to the back of the RB1, using the 2 M4 cross head screw. STEP 2: Using a 2.75" (70mm) hole saw, drill a hole in your selected location.
- Page 6 STEP 1: Place the RB1 cables in the rail found on the inner side of the surface mount plate, and screw the plate to the back of the RB1, using the 2 M4 cross head screw.
Need help?
Do you have a question about the RB1 and is the answer not in the manual?
Questions and answers