OSO 400 Installation, Operation & Programming Instructions

400
D
E
F
E
D
C
D
E
REMOTE CONTROL
OPERATION &
PROGRAMMING
OPERATING INSTRUCTIONS
POWER BASE HEAD AND FOOT
ADJUSTMENT
Adjusts the head and foot sections to
the desired positions.
FOUNDATION "FLAT" BUTTON
Return both head and foot to the flat
F
position.

ZERO GRAVITY

Allows your legs to be lifted to a
E
position slightly above the chest, which
enables blood flow to easily circulate
back to the heart, thus reducing stress
and fatigue.
A

LOCK

Press the Lock button for 3 seconds,
the remote will not be functional until
you press the lock key for 3 seconds
again.
B
PROGRAMMABLE MEMORY
BUTTONS
You can store 2 personalized memory
positions. Press and hold the "SET"
button for 3 seconds until the LED
light flashes once and then stays lit,
then press button "1" or "2" to store
the position. The LED will turn off
after the process is complete.

LIGHT

Press to turn on/off the Nightlight under
the bed.
HEAD AND FOOT MASSAGE
CONTROLS
Turns on the corresponding massage
unit (starting at intensity 5 of 10). To
increase massage intensity, press
(+) button. To decrease massage
intensity, press (-) button.

MASSAGE TIMER

Press the timer button to cycle the
operation time from 15-30-45-off.
CUSTOMER SERVICE: 800-973-8374
NOTE: If no time is set for the
massage, it will run for 30 minutes.
WIRELESS REMOTE PAIRING
PROCESS
STEP 1
Place batteries into the remote control
(3 x AAA batteries)
STEP 2
Ensure the power base is plugged into
a functioning outlet.
STEP 3
Press the pair button on the control
box for 3 seconds.
STEP 4
The indicator light will begin to flash
rapidly.
STEP 5
Press any button on the remote control
within 30 seconds to pair successfully.
STEP 6
When the receiver light stops flashing
and turns solid, you have completed
the learning process of the RF
frequency code.
NOTE: When you press multiple
buttons at the same time, the
system will identify an invalid
operation, except for special
combination keys.
CUSTOMERSERVICE@REVERIE.COM
3