Advertisement

Quick Links

ENG
GANTERUD L3
User manual
Version 2.0. 2022
www.ganterud.se

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the L3 and is the answer not in the manual?

Questions and answers

Summary of Contents for GANTERUD L3

  • Page 1 GANTERUD L3 User manual Version 2.0. 2022 www.ganterud.se...
  • Page 2 SS EN 61000-6-4 SS EN 60204-1 SS EN 61000-6-2 ELSÄK-FS 2008:1-4 Karlstad, 29/09/2022 Frögatan 10, SE 653 43 Karlstad Place and date Address Kristoffer Ganterud Authorised signatory Name in block capitals Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | info@ganterud.se...
  • Page 3: Table Of Contents

    7 Technical data ............. 22 3.2 Lifting capacity ..............10 3.2.1 Lifting table ...............11 3.2.2 Levelling expressed as height difference 12 3.3 Remote control..............13 3.4 Intended use ..............13 3.5 Disposal ................. 13 Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | info@ganterud.se...
  • Page 4: Introduction

    1.3 Warranty and complaints Ganterud Lifting Solutions AB guarantees that the product will be free from defects for a period of one (1) year from the date of delivery, provided the lifting yoke has been used, serviced and maintained in the prescribed manner.
  • Page 5: Safety

    Specifies a potentially hazardous situation that, if not avoided, may result in minor or moderate injury as well as damage to property. Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | info@ganterud.se...
  • Page 6: General

    There is a risk of crushing between the chain • The lifting yoke is only intended for lifting and the metal housing. loads using hooks/shackles. Any other use is prohibited. Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | info@ganterud.se...
  • Page 7: Incorrect Handling

    Both hooks must be used when lifting! The lifting The lifting yoke may be damaged in the event of yoke must not be used for lifting and hoisting an impact. using only one hook. Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | info@ganterud.se...
  • Page 8: Centring

    The load must be horizontal when placed on lifting may be carried out. a flat surface, or the load on both attachment points must be relieved at the same time. Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | info@ganterud.se...
  • Page 9: Safety During Operation

    • Check that the safety lock on each hook/the swing. pin on each shackle is properly locked. Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | info@ganterud.se...
  • Page 10: Description

    The lifting table applies during normal usage. In maximum lifting capacity will damage the the event of any uncertainty, scales/load cells equipment. must be used to measure the load at each end of the chain Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | info@ganterud.se...
  • Page 11: Lifting Table

    2 - 3 tonnes *5% displacement from the centre of gravity permitted. Chain Max. levelling angle, b angle, a 30° a = 20° 45° a = 20° 60° a = 10° Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | info@ganterud.se...
  • Page 12: Levelling Expressed As Height Difference

    1294 1553 1812 2071 1103 1378 1654 1929 2205 1169 1462 1754 2047 2339 1236 1545 1854 2163 2472 1302 1628 1953 2279 2605 1026 1368 1710 2052 2394 2736 Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | info@ganterud.se...
  • Page 13: Remote Control

    Changing the radio frequency may only be performed by authorised personnel. 3.4 Intended use Ganterud L3: The lifting yoke is intended for lifting objects with a maximum weight of 3 tonnes, as well as for levelling where the maximum imbalance between the attachments is 500 kg.
  • Page 14: Operation

    • that the locking mechanisms on the lifting hooks are working hooks are working • that the decals are clearly legible • that the decals are clearly legible Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | info@ganterud.se...
  • Page 15: Operating The Lifting Yoke

    Fast mode active. (Do not use when the yoke is carrying a load) Lower hook 1 (raises hook 2) Lower hook 2 (raises hook 1) On/Off Activates fast mode On/Off button for radio transmitter Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | info@ganterud.se...
  • Page 16: Calibration Of The Neutral Position

    When levelling, the chain’s end positions are governed by the neutral position that is calibrated in the factory. This should not normally need to be recalibrated. Contact Ganterud Lifting Solutions AB if you have any questions. Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | info@ganterud.se...
  • Page 17: Synchronising New Remote Control With

    Test all the functions on the lifting yoke. Note: take care and monitor both lifting yokes to make sure that no risk of injury can arise. 1 + 2 1 + A Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | info@ganterud.se...
  • Page 18: Tandem Operation

    5 Tandem operation Tandem operation of two GANTERUD L3 lifting yokes at the same time with one remote control. Start by deleting both the remote controls as described below: Make sure that the lifting yoke(s) are turned off with the power switch, and that the remote control(s) are turned off.
  • Page 19 3. Turn on “lifting yoke 1” and “remote control 1” and test all the functions on the lifting yoke. Then repeat this procedure with “lifting yoke 2”. 4. Note: take care and monitor both lifting yokes to make sure that no risk of injury can arise. Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | info@ganterud.se...
  • Page 20: Maintenance

    Replace the old batteries with new batteries and reassemble the remote control. Recycle the old batteries in accordance with local rules and regulations. Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | info@ganterud.se...
  • Page 21: Storage And Transport

    Never flush up under the plate over the chain wheel. 6.6 Inspection • GANTERUD L3 – the lifting yoke is not required to be inspected by a third party. • Visual inspection may be carried out by an inspector designated at the work site. •...
  • Page 22: Technical Data

    Optional extra equipment Number of function buttons ..5 Protective cover Power output .......12 MW Chain kit in other lengths Power supply....3 x 1.5V AAA Extra batteries IP rating ..........IP67 Transport packaging Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | info@ganterud.se...
  • Page 23 Variations in specifications and equipment standards may occur between different geographical markets. Please contact us for more information regarding applicable product specifications and local adaptations. Copyright © Ganterud Lifting Solutions AB | www.ganterud.se | info@ganterud.se...
  • Page 24 Ganterud Lifting Solutions AB Frögatan 10 SE 653 43 Karlstad Sweden www.ganterud.se...

Table of Contents