僅 Indicator Lights - Kia seltos 2023 Manual

Features of your vehicle
WARNING
Safe Stopping
僅 The TPMS cannot alert you to severe
and sudden tyre damage caused by
external factors.
僅 If you notice any vehicle instability,
immediately take your foot off the
accelerator pedal, apply the brakes
gradually with light force, and slowly
move to a safe position off the road.
LED headlamp warning light
(if equipped)
This warning light appears:
僅 When there is a malfunction with the
LED headlamp.
In this case, have the vehicle inspected
by a professional workshop. Kia recom-
mends to visit an authorised Kia dealer/
service partner.
Forward Safety warning light
(if equipped)
This warning light appears:
僅 Yellow:
- When you set the ignition switch or
ENGINE START/STOP button to the
ON position, it appears for approxi-
mately 3 seconds and then goes
off.
- When Forward Collision-Avoidance
Assist is Off/disable/malfunction.
In this case, have the vehicle
inspected by a professional work-
shop. Kia recommends to visit an
authorised Kia dealer/service part-
ner.
4 88
Warning and indicator lights
僅 Red:
- When Forward Collision-Avoidance
Assist is operating, it appears blink-
ing.
* For more details, refer to "Forward Col-
lision–Avoidance Assist (FCA) (Front
view camera only) (if equipped)" on
page 5-54 or "Forward Collision-
Avoidance Assist (FCA) (Sensor fusion)
(if equipped)" on page 5-65.
Icy Road warning light (if
equipped)
僅 This warning light is to warn
the driver the road may be icy
僅 When the temperature on the outside
temperature gauge is approximately
below 4 °C (39 °F), the Icy Road Warn-
ing Light and Outside Temperature
Gauge blinks and then appears. Also,
the warning chime sounds 1 time.
NOTICE
If the icy road warning light appears
whilst driving, you should drive more
attentively and safely, refraining from
over-speeding, rapid acceleration, sud-
den braking or sharp turning, etc.
Indicator lights
Electronic stability control (ESC)
indicator light
This indicator light appears:
僅 Once you set the ignition switch or
ENGINE START/STOP button to the
ON position.
- It appears for approximately 3 sec-
onds and then goes off.
(if equipped)