Linkworld Electronic LM5053 Quick Installation Manual

Wireless LM5053 Mouse
Quick Installation Guide

Hardware Installation

1. Turn the mouse upside down, then open their battery cover
2. Insert batteries, ensuring they are in the right type & direction.
3. Close their battery cover

ID Code Configuration

Your PC must be on to change the ID setting.
1. Press ID button on the side of the receiver once.
2. Press ID button on the bottom of the mouse once.
This ID-recognition function helps to portect against interence from other RF mouse
in the same environment. Remember to set the ID when you replace the batteries or
your mouse kits do not work properly.

Important

1. Whenever you insert battries, always make sure both of them are new.
Alkaline batteries are recommended.
2. Use the mouse on a clean, flat, non-slippery surface in order to
ensure smooth and accurate cursor action.

Mouse power management:

1. Whenever you insert battries or push the ID reset key on mouse ,the power- on
mold always starts on. & the"Sensor LED"light turns on.
2. Whenever you are continually pushing the ID reset key on mouse over 5 seconds,
the power- off mold always starts on. & the"Sensor LED"light turns off.
ID RESET KEY
ID RESET KEY