Advertisement
USB Driver Installation
TrackSense Pro Reader Station and Ellab Temperature Standard
This installation guide shows how to install the USB driver for the TrackSense Pro
Reader Station. The installation of the USB driver for the Ellab Temperature Standard
(ETS) can be installed in the same way.
Step 1:
Disconnect the USB device from the PC and run the file TsProUSBDriver300.EXE or
ETSUSBDriver300.EXE. Click Next.
Advertisement
Table of Contents
Summary of Contents for Ellab TrackSense Pro
- Page 1 USB Driver Installation TrackSense Pro Reader Station and Ellab Temperature Standard This installation guide shows how to install the USB driver for the TrackSense Pro Reader Station. The installation of the USB driver for the Ellab Temperature Standard (ETS) can be installed in the same way.
- Page 2 Step 2: Files are now being installed. Make sure the USB device is disconnected and then click Next. The driver is being installed. Step 3: Connect the USB device.
- Page 3 In Windows XP finish the “Found New Hardware” wizard as shown below. (Note that in Windows Vista these steps are done automatically by Vista. Just wait for Vista to tell that the driver is installed).
- Page 4 Click Finish at the end. Click Next in the Ellab installation of the USB driver. Step 4: Check in the Device manager that the USB device is installed. Click Next.
- Page 5 Step 5: Click Finish. The installation is complete..
Need help?
Do you have a question about the TrackSense Pro and is the answer not in the manual?
Questions and answers