Eastwood 55107 Instructions Manual page 4

ASSEMBLY
1. Align the holes on the back of the U-Bases [A] and the holes on the side of the Wheel Pole Upright [B]
(Fig. 1). NOTICE: Make sure the center caster holes are opposite of each other (Fig. 2).
2. Secure the two U-Bases [A] to the Wheel Pole Upright [B] by inserting the two M10x110 Shoulder
bolts, with M10 Washers, through all three members and tightening the M10 Nuts with Washers and
Lock Washers (Fig. 3).
3. Insert the Casters [E] up through the bottom of the U-Bases [A]. Insert the Stem Cap from the top
and hand tighten (Fig. 4). Use the supplied 5mm Hex Key and Flat Wrench to fully tighten the Stem
Cap onto the Casters [E] (Fig. 5). It is recommended to place the Locking Casters [F] on opposite
sides of the assembled base (Fig. 6).
4. Connect the Wheel Poles [C] and insert the connected poles into the Wheel Pole Upright [B] (Fig. 7).
5. Starting from the bottom hole in the pole, insert a Wheel Rest Pin [G] into the holes in the Wheel Pole
[C], assuring the Pin is resting on the pole within the grooved area on the Pin (Fig. 8).
6. Slide a Wheel Rest [D] down the pole with the flat side pointing up. Rest the Notches in the Wheel
Rest [D] on the Pin to secure it in place (Fig. 9)
7. Repeat the previous two steps three more times to assemble the remaining Wheel Rests [D] (Fig. 10).
FIG. 2 FIG. 2
Center
Caster
Holes
FIG. 5 FIG. 5
FIG. 8 FIG. 8
4
FIG. 3 FIG. 3
FIG. 6 FIG. 6
FIG. 9 FIG. 9
FIG. 1 FIG. 1
FIG. 4 FIG. 4
FIG. 7 FIG. 7
FIG. 10 FIG. 10
Eastwood Technical Assistance: 800.343.9353 >> tech@eastwood.com