Page 12
MANUAL INSTRUCTION AND INSTALLATION Read these instructions carefully before using this product and keep it for future use. SAVE THESE INSTRUCTIONS CAREFULLY SAFETY INSTRUCTION WARNING When using electrical appliances, basic safety precautions should be followed, including the following: • this appliance only for its intended purpose as described in the owner's manual. •...
Page 13
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. • Make sure that the installation of this appliance is allowed by the authorities. •...
If you need install wall switch (not included), you must do logo for on/off, and shall be installed by qualified professionals.Wall switch should be located convenient location on the work surface, separation of contact between the two blades at least 3 mm.Using a 20 amp grounded wall socket.
Page 15
COMPONENT IMPORTANT: Pay close attention to the order of the sink flange parts, as they have been correctly assembled by the factory. A. Disassemble the sink flange assembly from the disposer by turning the mount ring to the left (clockwise) and removing it.
Page 16
At this point you may want to insert the stopper in the sink and fill with water to check the sink flange seal and insure there are no leaks. Hand-tighten sink flange H . Place the mount ring over the sink flange and hold in place while installing the cushion mount (large side down).
Page 17
DISHWASHER CONNECTION (IF REQUIRED) If you are connecting to a dishwasher, complete the following step. If a dishwasher is not to be connected go on to "Attaching the Discharge Elbow" section 1. KNOCK OUT PLUG CONNECT HOSE Using a blunt instrument steel punch or wooden Connect the dishwasher hose using a hose clamp If the hose dowel knock out entire plug Do not use a screwdriver or sharp size is different, you will need a stepped...
Page 18
INSTALLATION INSTRUCTIONS (with the sink flange) 1. ATTACH TO SINK FLANGE 3. LOCK MOUNT RING Line up the disposer under the sink flange Turn the mount ring to the right until it locks up tight. Hopper Guide the hopper projections into the projections must be to the extreme left of the mounting slots If mount ring slots Turn the mount ring about the mount ring is hard to turn you may add a small amount of...
INSTALLATION DIAGRAM DIFFERENT TYPES OF INSTALLATIONS INSTALLATION WITH SINGLE BOWL SINK INSTALLATION WITH DOUBLE BOWL IMPORTANT: It is essential for the proper operation of the disposer that this dimension be 230 300mm depending upon the models listed above to avoid standing water in disposer motor housing. Flexible drainpipe may be necessary for this application...
Page 20
OPERATING INSTRUCTIONS This disposer uses anti-jam swivel impellers that make a clicking sound as they swing into place. This indicates normal operation. Operating Instructions Remove the sink stopper and turn on a medium flow of cold water. Turn on the wall switch Slowly insert food waste into disposer and position stopper to minimize possible ejection of material while grinding After grinding is complete turn disposer off and run water for at least 15 seconds to flush drain line HELPFUL HINTS...
CARE AND MAINTENANCE THE MOTORIS PERMANENTLY LUBRICATED FOR LIFE. DON T ATTEMPT TO LUBRICATE YOUR DISPOSER. The disposer is self-cleaning and scours itself with each use. ▪ NEVER put lye or chemical cleaners into the disposer, as they cause serious corrosion of metal parts. ▪...
Turntable cannot rotate If the turntable does not turn freely, check for an object lodged between the turntable and the grind Remove Splash ring. Dislodge the object by moving the turntable Guard with a broom handle. Then remove the Turntable object.
Need help?
Do you have a question about the FWD560+ and is the answer not in the manual?
Questions and answers