Advertisement
HOUR
CLEAR
CLOCK/TIMER
STAR/STOP/
MEMORY
• Slide and open the battery door of the unit, then insert the included batteries following the
correct polarity + and – signs inside the battery compartment.
• Press and hold "CLOCK/TIMER" button for 2 seconds and press "HR", "MIN", "SEC" buttons to
set desired time.
• Press "CLOCK/TIMER" button again to leave clock set mode.
• Press "START" to begin counting upward in "CLOCK" mode. Press "STOP" to pause timing.
To restart, press "START"
• Press "CLEAR" to reset digits to 00HR 00MIN 00SEC.
• Press "CLOCK/TIMER" button to change into "TIMER" mode.
• Press "HR" "MIN" "SEC" buttons to set desired time.
• Press "T1" again to leave TIMER set mode.
• Press "START" button to begin count down.
• Press "STOP" button to pause timing. To restart, press "START" button again.
• Alarm Duration: 1 minute
• Press and hold T2 or T3 for 2 seconds and operate the same as point 4 above.
MINUTE
SECOND
TIMER 1
TIMER 2
TIMER 3
CLIP
Magnet for metal
surface attachment
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Marathon TI030007
Summary of Contents for Marathon TI030007
- Page 1 MINUTE HOUR SECOND CLIP TIMER 1 CLEAR Magnet for metal surface attachment TIMER 2 CLOCK/TIMER TIMER 3 STAR/STOP/ MEMORY • Slide and open the battery door of the unit, then insert the included batteries following the correct polarity + and – signs inside the battery compartment. •...
- Page 2 • The timer will count-up from 0:00:00 to tell you how much time has lapsed since the alarm sounded. To stop count-up, press “STOP” button. • Press “CLEAR” button to reset the timer. • After alarm beep, press “START/STOP” button or “START/STOP/MEMORY” button again, the last countdown timer will be recalled and shown on the display.
Need help?
Do you have a question about the TI030007 and is the answer not in the manual?
Questions and answers