QUATROS QS19309 Owner's Manual

OWNER'SMANUAL
ENGINE STAND 450KG
QS19309
DESCRIPTION
Engine Stand 450kg QS19309:
SAFETY INSTRUCTIONS
WARNING
- DO NOT exceed the maximum capacity of 450kg. Overloading could result in loss of load and/or personal injury or property
damage.
- Always use stand on hard level surface capable of sustaining the load.
- Never work directly under a suspended engine.
- Do not attempt to move the stand when under load. The casters are not designed to be rolled when the stand
is supporting a heavy weight. If you need to move the engine you must transfer it to an approved, appropriate moving
device such as an engine hoist.
- Make sure that stand is stable. Before using the stand check it for cracks, bends in the material or signs of unusual wear.
If any are found do not use the stand. Take it to an authorized technician for service or repair.
- Do not attempt to remove an engine from a vehicle using this device. Use an engine hoist (not included).
- Be careful not to pinch fingers and hands when adjusting and using the engine stand.
- Be sure that the load is centered and secured to the mounting plate.
- Do not drop load suddenly as resulting shock to unit may cause damage.
- Before each use ensure that all nuts and bolts are correctly fitted and tight. Do not substitute hardware provided.
- Failure to follow these instructions could result in loss of load and/or personal injury or property damage.
OPERATION
WARNING! Ensure that you read, understand and apply the safety instructions.
The warnings, cautions and instructions discussed in this instruction manual cannot cover a possible conditions and situations that
may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product
but must be supplied by the operator.
OPERATION
1. Remove the engine from the vehicle by engine hoist/engine crane.
2. Connect the motor to the stand. Put the bolts through engine stand fingers (#2) and screw in place of the holes connecting
the engine with the gearbox.
3. Make sure all bolts are tightened.
INSPECTION
- Visual inspection should be made before each use of the engine stand.
- Any engine stand which appears to be damaged in any way is found to be badly worn or operated abnormally must be
removed from service.
- If the engine stand is accidentally subjected to an abnormal load or shock it must be inspected by the manufacturer
immediately.
- It is recommended that an annual inspection of the engine stand be made and that any defective parts, decals or warning
labels be replaced with manufacturer's specified parts.
IMPORTER
Capacity: 450kg | Height: 800mm
:
PW TECHSAM Woch Sp. J.
ul. Warszawska 131
20-824 Lublin
www.quatros.eu
a
a
| Weight: 21kg
tel. 81 444-63-73
tel. 81 443-08-12
fax 81 458-38-19
e-mail: techsam@quatros.pl