Page 1
Owner's Manual and Installation Instructions Original Instructions CAUTION Read this document before operating or servicing the sprayer. This document is for SnowEx SL-80 and SL-80SS walk-behind sprayers beginning with ® serial numbers 170301 and higher. This document supersedes all editions with an earlier date.
Page 2
Lit. No. 74419, Rev. 01 November 1, 2017...
PREFACE This manual has been prepared to acquaint you with When service is necessary, bring your walk-behind the safety information, operation, and maintenance sprayer to your distributor. They know your sprayer of your new walk-behind sprayer. Please read this best and are interested in your complete satisfaction. manual carefully and follow all recommendations.
2-Digit Location Code to damage to your sprayer and vehicle or other #### 4-Digit Sequential Number property. Other useful information can also be SL-80 Model Number described. SL-80SS Model Number www.snowexproducts.com www.snowexproducts.com Lit. No. 74419, Rev. 01 November 1, 2017...
Page 7
SAFETY SAFETY PRECAUTIONS PERSONAL SAFETY Improper installation and operation could cause • Wear only snug-fi tting clothing while working on personal injury and/or equipment and property your sprayer. damage. Read and understand labels and this • Do not wear jewelry or a necktie, and secure long Owner's Manual before installing, operating, or making hair.
Page 8
SAFETY CHEMICAL ACCIDENT PROCEDURES Sprayer leak If the sprayer develops a leak, immediately stop spraying. Turn OFF power to the sprayer and follow directions below, as applicable. Bodily chemical Personal contamination can occur when chemicals splash, spill, or spray directly onto contact a person.
Page 9
SAFETY DURING OPERATION DURING ASSEMBLY • Read and follow each chemical label's instructions Check and test completed assembly as directed in and warnings. this manual. Serious injury could result from chemical leaks if sprayer is improperly assembled. • Avoid inhaling, ingesting, or coming into contact with any chemicals.
Page 10
SAFETY BEFORE SPRAYING DURING SPRAYING • Inspect and prepare sprayer before each use as • Do not over-apply. Apply at a rate recommended directed in this manual. by the chemical manufacturer. • Do not start sprayer until ready to spray in order to •...
Page 11
SAFETY AFTER SPRAYING TRANSPORTING SAFETY • Decontaminate yourself after you are done • Exercise caution in vehicle handling when driving spraying and have cleaned the sprayer. Wash all with sprayer to avoid loss of control or rollover. exposed areas of the body with soap and water, and remove and launder clothing.
ASSEMBLY TIRE INFLATION 5. Remove, reverse, and reinstall the nozzle bracket on the front of the unit. Be sure the spray opening on the nozzle body is pointing down. WARNING Use safety glasses and gloves when infl ating and installing the tires. Use manual pump only to infl...
ASSEMBLY & OPERATING THE SPRAYER SPRAYER OPERATION 6. Install the included spray nozzle to the nozzle body. 1. Be sure that the pump switch is in the "OFF" position. 2. Fill the sprayer with liquid through the port on the top of the tank.
TROUBLESHOOTING TROUBLESHOOTING Whenever service is necessary, the local SnowEx dealer knows the sprayer best. Take the ® sprayer to the local dealer for any maintenance or service needs on the unit. If this is not possible, the troubleshooting guide below may assist in identifying the problem.
MAINTENANCE MAINTENANCE 1. Grease axle zerks after every 20 hours of use. 2. When putting the unit into storage for the season, drain the tank and hose lines, and fl ush the pump. Lit. No. 74419, Rev. 01 November 1, 2017...
Page 16
TrynEx International may require or recommend optional equipment for sprayers. TrynEx International offers a limited warranty for all sprayers and accessories. See separately printed page for this important information. The following are registered ( ) trademarks of Douglas Dynamics, LLC: SnowEx ® ®...
Need help?
Do you have a question about the SL-80SS and is the answer not in the manual?
Questions and answers