Table of Contents
Advertisement
When unpacking, check to make sure the following parts are included:
- Vibrator Motor Assembly
If any parts are missing or broken, please call Harbor Freight Tools at the number on the
cover of this manual as soon as possible.
1.
Guide the Cylindrical Plug (A14) into the Gear Box so that its grooves align inside.
2.
Then, push the Cylindrical Connector all the way in the Gear Box while aligning its
notches to meet the Connecting Spanner (1).
3.
Turn the Spanner until it locks the Cylindrical Connector in place.
1.
Connect the Plug (19) to an electrical outlet or extension cord.
If using an extension cord, refer to the Safety Precaution #18 on page 3.
2.
Carry the Vibrator Motor by the Supporting Bracket (8) and the Vibrator Head with
Flexible Pipe to where the cement is being poured. Place it in a dry area, away from
water and the concrete.
CAUTION: Never carry the Vibrator Motor suspended from the Flexible Pipe. This could
damage the Gear Box or Cylindrical Connector.
3.
After pouring the concrete, press the Switch (51) to the ON position.
The Vibrator Head should begin to move. If it does not, tap it until
the vibration starts. If it still does not, turn the unit OFF and recheck
electrical and mechanical connections.
WARNING: Never let wet concrete or water come in contact with the
Motor. This could cause an electric shock to the operator, viewers,
or cause damage to the Motor.
4.
Insert the Vibrator Head with Flexible Pipe Assembly into the concrete.
5.
Move the Vibrator Head up and down in the concrete to remove air bubbles.
Caution: Never allow concrete to enter the Vibrator Head Assembly. This could damage
the bearing inside the Head.
SKU 42947
For technical questions, please call 1-800-444-3353.
Unpacking
- Vibrator Head with Flexible Pipe Assembly
Assembly
Cylindrical Connector (A16)
Notches
Operation
Grooves
Cylindrical Plug (A14)
Switch (51)
REV 05/06
Page 5
Advertisement
Table of Contents
